Add an electric socket to an existing light circuit (230v AC)

Can I run a socket off a lighting circuit?

Technically, you can wire a socket onto a light circuit, but it is not recommended. There can be problems with overloading the circuit. If you add a socket to a lighting circuit, do it in parallel. Otherwise, the light switch will control the circuit.

Can you spur off a socket for a light?

You need the neutral to make the light work but you can take a spur from the socket underneath the desk for a light, you could place a FCU next to socket underneath desk then run cable to light switch and then on to light fitting .. you cannot run spur to spur with sockets incase of over load of cable but a light is …

How do I add a socket to an existing circuit?

Isolate the circuit and use a voltage tester to double check that the existing socket is dead.

1. Unscrew the faceplate of the new socket, feed the cable into the mounting box through a rubber grommet and connect its cores to the faceplate terminals. …
2. Cut the cable and do the same at the existing socket.

How do you add a plug to a hardwire light?

How to Convert a Hardwired Fixture to Plug-In:

1. Choose a light fixture to convert.
2. Locate, Separate, and Strip Wires.
3. Acquire a new plug with removable parts.
4. Prepare & Open Replacement Plug.
5. Remove Prongs & Loosen Screws.
6. Thread the new Plug onto Light Fixture’s Cord.
7. Attach each wire to 1 Prong.
8. Reassemble Plug with New Wires.

Can I add a light to an existing circuit?

You can usually install a light fixture between an existing one and the switch by cutting the cable to the existing fixture at the location of the new one, inserting the ends of the cable into the electrical box for the new fixture and pigtailing the new fixture onto these wires.

Can I put a plug on a ceiling light?

Yes, you can get a plug and attach the two wires from the cord to the non-earth (ground) pins of the plug. Look for something like this – you strip some insulation off the end of your cord, open the plug, attach the wires to the appropriate pins, and close the plug which also clamps the cord in place.

How do you run power from an outlet to a light?

Youtube quote:What we'll do is we will take our white one and hook it up to the silver side and tighten it. Up. Then we'll go ahead and hook up our ground.

Can you power a switch from an outlet?

Switch boxes can sometimes be used as a power source for a new outlet, but only if the box is large enough and has neutral and ground wires running through it.