How do you connect copper pipe to wood?

Quote from the video:
Quote from Youtube video: You are a glue and machines. We're going to pre-drill some holes into this piece of wood. Good keep it spinning. And then pull out. Great.

How do you solder in tight space?





Quote from the video:
Quote from Youtube video: So in this case we're actually going to be only heating up the fitting. Itself inside we have flux. And when we apply heat to the fitting. And when we spread our solder.

How do you join copper pipe without soldering?

Quote from the video:
Quote from Youtube video: Looking for an easy way to join solid copper together and you don't like to solder you don't know how to these new push fit fittings are an excellent way to join copper.

How far does copper pipe go into fitting?

As the solder melts, it will flow into the fitting. Solder flows toward the hottest part of the metal. Allow 1/2 to 3/4 inches of solder to flow into the joint. This will likely match your pipe diameter.

What is the best way to connect copper pipe?

Quote from the video:
Quote from Youtube video: So all you need to do is clean this end flux it slip this on and heat it up and you'll see the ring come around here when it's when it gets hot. Enough. You don't even have to heat it up. Much.

What is the difference between copper pipe and copper tubing?





Tubing is usually more expensive than pipe due to tighter manufacturing tolerances. Interestingly, while the stated and measured OD’s of tubing are almost exact in most cases, copper tubing generally has a measured OD that is 1/8” larger than stated OD. As such, maybe it should be called copper pipe.

Why do copper pipes go green?

Patina, or the greenish colour that appears on copper pipes, happens from oxidation. Oxidation is common on copper when it is exposed to water and air over time. While this oxidized layer is not harmful, it does cause the copper to become corroded.

What is the difference between red and blue copper pipe?

The color assists in identifying the type of copper pipe. Green represents type K, blue represents type L, red represents type M, and yellow represents type DWV. Thus, type L copper pipes are also known as blue and type M copper pipes are also known as red.

Is PEX better than copper?

PEX doesn’t degrade like copper, higher PSI rating freezing pipes will still burst, but PEX will be able to handle more freezing water than copper. PEX Tubing is much more resistant to freeze-breakage than copper or rigid plastic pipe. PEX Tubing is cheaper because it takes much less labor to install.

Why do plumbers use PEX?



PEX tubing minimizes the need for connectors since it’s so flexible. Connection sites have the highest potential of leaks in your plumbing system, so fewer PEX fittings leads to less risks of leaks.

Do rats eat PEX pipe?

The Problem



Mice and rats will chew through anything they can, including plastic, so PEX tubing is at just as much risk as the plastic-coated wiring in a car or an HVAC unit. While all rodent damage can be expensive, if rodents chew through a home’s PEX water pipes, the result can be disastrous.

Where should you not use PEX?

PEX can’t be installed in high heat areas.



You can’t install PEX in high heat areas like near recessed lighting. This also means you can’t connect PEX directly to a hot water heater, but you can use a connecting material to do this.

Can PEX touch copper?



PEX does not corrode, which can happen with both copper and steel pipes, leading to leaks and contamination of the water supply.

What are 2 disadvantages to using copper pipe?