How to Hang Drywall Around a Bathtub

  1. Step 1: Measure the Bathtub Area. …
  2. Step 2: Cut Water-Resistant Drywall. …
  3. Step 3: Secure Drywall With Screws. …
  4. Step 4: Measure the Drain End Wall. …
  5. Step 5: Cut Holes for Faucets. …
  6. Step 6: Install Side Wall Drywall. …
  7. Step 7: Tape, Mud and Sand Joints.

Can you install a tub over drywall?

The short answer to the question is, “It’s not recommended.” However, this answer only really only suffices if you’re converting a room that was never a bathroom into a wet space. Drywall on its own is not suitable for use in bathrooms because it is prone to absorbing moisture and thus losing structural integrity.

Can you install a tub surround over drywall?





Adhesive surround kits can be installed over just about any flat wall surface in good condition, including tile or drywall. But because the panels are glued, the walls need to be clean so that the adhesive will make good contact. Walls that are damaged will also need to be patched first.

How do you drywall around a tub surround?

Quote from the video:
Quote from Youtube video: And then run it over the top and run it up against the top not a bad option the other option of course is to just mud it and then run mesh tape over the top mud it again with a skim coat and sand it.

What do you do with space between bathtub and wall?

If you have tile on the wall adjoining the tub, select a caulk that matches the color of the grout. If your gap is smaller than 1/8 inch in width, use regular caulk; fill gaps larger than 1/8 inch with a sanded caulk. Make sure the gap is clean and dry, then squeeze a thin, even bead of caulk into the space.

How do you fill the gap between drywall and bathtub?

Quote from the video:
Quote from Youtube video: Everything needs something to bond to mix up some 20-minute speed set joint compound. And press it into the gap keeping it flush with the drywall.

Does drywall go over lip bathtub?





If so, you’ve come to the right place. We’ve done the research to provide you with the answers you need to install your bathtub properly. Whether backer board or drywall, your surround material should rest on the edge of the tub flange but should not make contact with the lip.

What goes behind tub surround?

Install cement board or an equivalent moisture-resistant backing material on walls behind tub and shower enclosures composed of tile or panel assemblies with caulked joints. Don’t use paper-faced backer board, i.e., paper-faced drywall, behind seamed tub and shower enclosures.

What do you do with a gap between tub and cement board?

The best approach when installing cement board or other tile backer around a tub is to keep the cement board out of the lip area. Apply it to the wall with the bottom edge about 1/4 in. above the lip of the tub. Then apply a generous amount of thin-set to the bottom bathtub tile and position it 1/8 in.

How do you waterproof drywall above a shower?

Quote from the video:
Quote from Youtube video: So I cut a piece of the kerdi-band. And what we're going to do is just put it right over top of the drywall here using unmodified thinset. So you can see I just cut it down with size.

Can you waterproof drywall for shower?



It is possible to waterproof drywall in a shower by covering the drywall with a waterproof membrane. This waterproof membrane can be bonded to drywall with thinset adhesive to create a waterproof layer. Never tile directly over drywall in a shower.

Can you use drywall above a shower?

The drywall designed for a bathroom is moisture-resistant, but not waterproof, and needs protection from the humid conditions in the shower. Among the options for covering it are to paint the wallboard or glue on vinyl paneling. The right kind of paint provides adequate protection in most cases.

Is there waterproof drywall?

Water-resistant drywall has been around for more than 25 years. It is known in the trade as greenboard because of its green paper facing. It is a great product when used exactly as it was designed to be used. I have had great success using greenboard behind sinks and toilets and on walls with ceramic-tile backsplashes.

Do bathrooms need special drywall?



Drywall for bathrooms has special moisture-, mold- and mildew-resistant qualities, but it’s not 100 percent waterproof. Tub and shower surrounds require the use of other materials like backer board, but it’s common to use green board or MMR drywall on the walls and ceilings.

Is Greenboard required in bathrooms?

Green boards are often required by local building codes to be used as a backing for tiles and wall panels in areas that are exposed to moisture; this includes bathrooms, laundry rooms, and kitchens. However, they are not allowed for use in parts of the home that have excess humidity, like near indoor pools.