Check the fan motor, it might be faulty. Also, try changing the capacitor since some motors are capacitor run for starting….the capacitor charging and discharging have issues.
Why does my blower motor work sometimes?
When a blower resistor fails, the highest fan speed usually is the only one that still works because it essentially bypasses the resistor and receives the maximum amount of voltage. When the resistor is working, it reduces the amount of voltage going to the lower fan speeds so the fan runs slower.
How do I reset my blower motor?
How to Find and Reset your Furnace Motor Blower
- Step 1: Turn off the power to the furnace. …
- Step 2: Remove the blower compartment cover. …
- Step 3: Make sure the blower is completely cooled off. …
- Step 4: Locate the reset button. …
- Step 5: Press the button in (assuming that this is your issue and that the button has popped).
What would cause a furnace blower not to kick on?
If you see or hear the fan turn on, your blower motor is not the culprit. If the fan does not start, you have a wiring issue (circuit breaker trips) or motor problem (circuit breaker does not trip). While your thermostat may be at fault, only an HVAC technician can diagnose and remedy the issue correctly.
What happens when blower motor resistor goes out?
If the resistor shorts or fails, it may cause the blower motor to remain stuck on one fan speed. The heating and air conditioning systems may still function at one speed, however the resistor will have to be replaced in order for full functionality to be restored.
How do I know if my blower motor relay is bad?
If you have a faulty blower motor, you may experience low airflow from the vents, even when the fan is on high. There will be no air coming from the vents if your fan isn’t working due to a bad blower motor resistor. Blown relay circuit fuses or melted relays are more serious signs of a bad blower motor relay.
How do I know if my blower motor switch is bad?
- Switch only works on certain settings. One of the first symptoms commonly associated with a bad or failing blower motor switch is a switch that only works on certain settings. …
- Switch is stuck. Another symptom of a bad or failing blower motor switch is a switch that is stuck, or frequently gets stuck. …
- Broken knob.
Where is the blower reset button?
Locate the reset button on the furnace and press it to reset the furnace. It is usually located inside the blower compartment on the side of the blower motor. Be cautious as the housing may be hot. If the button is popped up, press it down.
Why will a blower run on the on position and not on auto?
That’s because if the heater never warms up then the fan controller won’t automagically turn on the blower fan. Let me know what you find. Electric split unit trane the fan comes on in the on position but not in automatic. Heat or cool isn’t working on the condenser or evaporator .
Is there a fuse for the blower motor?
Fuse Protection
To protect the blower motor power circuit, a 20-, 25- or 30-amp fuse is usually located in the fuse panel under the dash. The rating of the fuse will depend on the vehicle application and how much power the blower motor requires at full speed.
Where is the blower fuse located?
Under the instrument panel, look under the glove box. On the right side of the fender wall you will find another fuse box. The blower motor fuse is easy to replace.
Where is the blower motor fuse relay?
The blower relay is located near the front of the fuse block and is labeled “Blower.” Inspect the center of the relay. If the metal rod inside is broken, the relay will need to be replaced.
