The Valves Need to Be Replaced If it’s the faucet in your bathtub that won’t shut off, the problem may be the valves. These valves are what control the flow of water, and if they’ve worn out, the only way to deal with this issue is to replace them.

What do you do when your bathtub faucet won’t turn off?

Quote from the video:
Quote from Youtube video: But if you cannot. You just need to buy this a little assembly thing and it's always a good idea if you're going to replace the hot one or the cold one you replace the other one as well.

Is there a water shut off valve for a bathtub?

Quote from the video:
Quote from Youtube video: So basically what you're going to have to end up doing is opening up this lid. And inside locating. Your water shut off once you've done that you can simply use your same tool that you use to open.

How do I turn off cold water in my tub?

Turn off the cold water valve above the water heater. This may be a lever or a regular circular-handle valve. If it’s a lever, pull it 90 degrees from its open position. If it’s a circular valve, turn it clockwise until it is closed.

How do I stop my tub faucet from running?

Quote from the video:
Quote from Youtube video: On this one you knit then remove the sleeve or the sketching tube. And keeper pin and then you'll be able to remove the cartridge itself now this particular cartridge pulls.

Why does my faucet continue to run after I turn it off?

If the water still runs after shut off, it’s most likely because of a problem with the seal. This occurs from issues with the hardware inside the faucet.

Can you change a bathtub faucet without turning the water off?

If you are really just replacing the handle – which is really items 1-4 (and sometimes 5-6 or sometimes 5-6 don’t exist) – then no you do not need to turn off the water.

Where is the water shut-off valve for a shower?

This supply valve is usually near the bottom left side of the toilet tank. For showers/tubs, look around the tub or shower for an access panel. It may be on the other side of the wall from the tub or shower.

How do I replace a bathtub valve?

Quote from the video:
Quote from Youtube video: Step 1 turn off the water to the bathtub. And shower at the shutoff valve let any remaining water flow out of the faucet. Step 2 remove the cap and screw from the faucet handle using a screwdriver.

Do showers have their own water shut-off valve?

There usually is not a shutoff valve for just the shower. The toilet has it’s own shutoff, and sinks have their own shutoffs under the sink. But tub and showers typically do not have their own shutoffs.

Why does my faucet keep running when I turn on my shower?

If your tub’s spigot continues to run even when you turn on your shower, you most likely have an old or faulty shower diverter valve.

Why is my shower water not turning off?

A shower that won’t turn off is often because of an issue with the cartridge. Replacing the shower cartridge is a bit trickier than tightening the faucet handle, but if you follow these steps, you should be able to change the shower cartridge. Turn the water off again. Turn hot and cold water on in another room.

How do you fix a shut-off valve that won’t turn off?

Quote from the video:
Quote from Youtube video: You want to put your wrench. On this nut and turn it counterclockwise to remove the entire stem from the body of the valve. Place a bucket under the valve. And then turn this nut counterclockwise.

How do you fix a stuck water valve?

Quote from the video:
Quote from Youtube video: This can cause the valve to freeze up and become stuck the first thing to try is to hold the valve body. And put a cloth over the handle to protect your hand. And then try to rock the valve back and

How do you fix a water shut-off valve?

First shut off the water to the leaking water valve. Next remove the handle from the stem and then loosen and remove the packing nut. Remove the old washer and slide on the new one. Reinstall the packing nut, tighten lightly with a wrench (don’t over tighten at this or any other point) and reattach the handle.

Can water shut off valves fail?

Common Valve Failures



As time takes its toll on these trusted devices, they can become prone to failure. The most common failure found in an old shut-off valve is seizing. This means that you may be unable to turn it off by hand, which is a very, important function.

How can you tell if a water valve is bad?

If you have no water pressure throughout the house on both the hot and cold, your PRV may be bad. Make sure you check both the hot and cold water. If there is good pressure on the cold and not the hot it may be an issue with the water heater or the fixture itself.

How do I know if my water valve is broken?

Quote from the video:
Quote from Youtube video: It just spins and spins and spins is this the actual valve in the house that's never a good sign. Oh. No so now it is closed it is broken in the partially. Open conditions.