Where can I run my condensate pump drain line?
Quote from the video:
Quote from Youtube video: We piping this down to the lowest point in the attic this is a retrofit. Job we've already taken the liberty of insulating.
How do I connect my humidifier to my furnace?
Quote from the video:
Quote from Youtube video: And it's your best bet to go ahead and take a look at that look at the furnace that you have between the two you'll be able to figure out the wiring from.
How do you hook up a drain pipe to a dehumidifier?
Quote from the video:
Quote from Youtube video: And allows you to drain the water to a sink or outside a window some dehumidifiers have an internal condensate pump so all you have to do is attach the hose to the pump port.
How do you hook up a water line to a humidifier?
Quote from the video:
Quote from Youtube video: And this is self piercing it has a needle valve that is going to cut its own hole into the copper tubing. And then as we unscrew this allow the flow of water to go into our humidifier.
How do I connect condensate pipe to waste pipe?
The process of connecting a condensate pipe to a waste pipe is actually quite simple.
- What You Need.
- Step 1 – Turn the Boiler Off.
- Step 2 – Locate the Waste Pipe You Want to Tap Into.
- Step 3 – Cut into Waste Pipe.
- Step 4 – Attach Condensate Pipe Clamp.
- Step 5 – Attach Condensate Pipe to Clamp.
How do you tap into a PVC drain pipe?
Quote from the video:
Quote from Youtube video: For this job we'll be using a battery-powered saw our glue and primer and a marker so if you're wanting to tie in with a tea to your pipes. You'll take the tea. Place it over the pipe.
How do I tap into my main drain line?
Quote from the video:
Quote from Youtube video: After everything's clean and dry go ahead and glue your pipes. Now after it's glued we'll go ahead and put our pipe into position. And take the support brackets that they've given us.
How do you tie into an existing plumbing drain?
Cut out a section of pipe, lay in the new pipe, and use couplers to seal the deal.
- Step 1 – Cut Out Old Pipe. Remove a section of the existing pipe to the same size of the pipe you want to add in. …
- Step 2 – Insert Couplings. …
- Step 3 – Lay in New Pipe. …
- Step 4 – Tighten Couplings. …
- Step 5 – Test for Leaks.
How do you tap into a cold water line?
Quote from the video:
Quote from Youtube video: Open up the filter compartment twist the bypass cap counterclockwise to take it off take off the foil from the filter. Then twist open clockwise to get it to go in shut the compartment.
How do you tap into hot and cold water lines?
Quote from the video:
Quote from Youtube video: This i would drill a hole right here i'd run a hot water line out to this faucet. And then i'd add this yolk to pop between both faucets.
