What causes a pool heat exchanger to fail?
When water gets hot inside the copper/cupero nickel tubes, calcium wants to seperates from the water molecules and sticks to the hot tubes of the exchanger. When this happens, calcium deposits build up inside the tubes over time.
How do you set up a Hayward pool heater?
Youtube quote:The water pressure switch is preset at the factory. For the majority of installations. In cases where the heater is installed either below the surface of the pool or above the surface of the pool.
How do you plumb a Hayward pool heater?
Youtube quote:The heater ships with a 240 volt plug installed on the fuse circuit board located in the electrical.
How long do pool heat exchangers last?
With proper installation and maintenance, heat pump pool heaters can last 10 or more years.
Why does my Pentair pool heater keep shutting off?
To troubleshoot your Pentair pool heater to keep it from tripping, you need to check the pH level of your pool because incorrect water chemistry will damage your pool’s gas exchanger and cause the heater to trip. Ensure the water chemistry is balanced or get heaters that are less corrosive to water chemistry.
What size heat exchanger do I need for my pool?
Determine pool capacity. Rectangular Pool Capacity = 7.5 x Length (ft) x Width (ft) x Average Depth (ft). Circular Pool Capacity = 5.9 x Diameter2 (ft) x Average Depth (ft).
How does pool heat exchanger work?
Swimming pool heat exchangers work by transferring heat energy from a hot water circuit, to the cooler pool water circuit, without the two fluids ever coming in direct contact with each other. Most swimming pools are heated via a boiler, using fuels such as Gas, LPG or Biomass, as the energy source.
Is the cupro nickel heat exchanger worth it?
Cupro-nickel is a copper-nickel alloy made to resist the corrosiveness of salt water. Therefore, it is a great choice for those looking for a cupro-nickel heat exchanger for their salt water pools, and many applications in the marine environment.
How do you put a Hayward heater in bypass mode?
Press the Mode button to place the heater in Standby Mode. Hold the Down Arrow and Mode buttons simultaneously for 3 seconds for Bypass operation.
How far should pool heater be from pool?
approximately 25 feet away
Install the heater as close to the filter as possible and approximately 25 feet away from the swimming pool. Installing the unit any farther may cause heat loss since tubing is underground. An “ideal” installation will have about 24″ of clearance around the unit with no obstructions above.
How do I use my Hayward heat Pro?
Youtube quote:It is truly the most energy efficient way to maintain your pool at the perfect temperature. So you can swim every day.
What does LP mean on a Hayward heat pump?
low-pressure
The low-pressure switch will shut the heat pump down when the evaporator starts to freeze. When the unit starts to freeze the low-pressure switch will be tripped, causing the display to read “LP” This will prevent the evaporator from becoming damaged or deformed.
What does LP mean on Hayward pool heater?
Hayward Heat Pro Heat Pump Flashes error code LP
Through online searches this stands for Low Pressure but sounds like it can be caused by a bunch of stuff other than just a freon leak, like a bad fan motor, start capacitor, control board, etc., etc.
What does PS mean on Hayward pool heater?
Adequate water flow through the heat pump causes the Water Pressure Switch contacts to close. Insufficient water pressure will allow these contacts to open, and turn the heat pump off. The display will read “PS” if the water pressure is not sufficient.
Why does my Hayward Pool say Lo?
The Hayward heater LO code indicates a fault in the temperature limit switch, vent pressure switch, or water pressure switch. To fix it, ensure the pump is on, is wired and connected well, the water flow is above the required minimum pressure, the filters are clean. Replace defective switches.
