Can you widen a closet opening?
Use a reciprocating saw to cut any of the framing out of the way. Reframe the opening, using 2-by-4 studs on each side of the new opening. Make sure the new 2-by-4’s are plumb and level. Install the pre-hung door unit.
How do I make my closet door bigger?
Quote from the video:
Quote from Youtube video: After we add back a continuous 2×4. And drywall we will have a total of eight and a half inches from floor to header to be able to install the new sliding. Door you can watch one of my previous.
How do you widen the opening on a load bearing wall?
Quote from the video:
Quote from Youtube video: But I can't just remove those studs because the load above won't be supported by installing a header across the opening it gives the load a path that load will be spread across the header.
Is my closet load bearing?
To determine if a wall is a load-bearing one, Tom suggests going down to the basement or attic to see which way the joists run. If the wall is parallel to the joists, it’s probably not load-bearing. If the wall is perpendicular, it’s most likely load-bearing.
Can you make a closet bigger?
Related Articles. Bedroom closets can be enlarged to create more walk-in space, to hang more clothes or both. With some floor plans, closet walls in bedrooms that are separated by a common wall extend into each room, creating offsets.
How much does it cost to expand a closet?
However, most homeowners spend an average of only $358 to remodel their closet, but prices range from $644-$1,275 on the high end. A small reach-in closet will cost less than a large walk-in closet.
Closet remodel cost:
| National average cost | $358 |
|---|---|
| Low-end cost range | $113-$271 |
| High-end cost range | $644-$1,275 |
How can I raise my door opening?
Cut new side jambs that are long enough to fit in the new opening. Nail them to the top jamb, then install the jamb into the rough opening, using cedar shims and a level to make sure the top is horizontal and the sides vertical.
Is a closet header load bearing?
Automatically, builders know that a two-by-four header means either an interior, non-load-bearing wall (one that doesn’t support the roof and a second story, if applicable) or an opening 3 feet wide or less. A regular header, on the other hand, must be used for load-bearing walls, whether interior or exterior.
What happens if you knock out a load-bearing wall?
Removing a load bearing wall may create structural problems in a home, including sagging ceilings, unleveled floors, drywall cracks, and sticking doors.
How thick are closet walls?
A two-by-four wall stud is 3 ½ inches wide, and an interior wall typically has ½-inch drywall installed on both sides, bringing the wall thickness to 4 ½ inches. Walls that contain plumbing, such as walls behind sinks, however, should be thicker than standard walls.
How far apart are studs?
The general spacing for wall studs is 16 inches on center, but they can be 24 inches. At my home, the exterior wall studs are spaced at 24-inch centers, but the interior walls are 16 inches on center.
What is the standard depth for a closet?
24 inches deep
A clothes closet should have a minimum depth of at least 24 inches deep, so the clothes can clear the back wall.
