Electrical Fault If your GFCI outlet trips consistently, it could be an electric fault resulting from faulty structural wiring. An electrical outlet connected to the same circuit could also be the source of the problem, especially if it was not part of the original wiring of your home.

Why does my GFCI outlet keep tripping in garage?

Most likely, your outdoor GFCI outlet is tripping due to one of these 3 problems: There’s a ground fault somewhere in the circuit. Moisture invaded the receptacle box. The GFCI outlet is faulty.

How do you fix a GFCI outlet that keeps tripping?





Solution: Remove the GFCI outlet and replace it. If the problem is fixed, then you know that the GFCI was the initial cause of the tripping. If removing the outlet, and the problem persists, it is likely that it could be another outlet on the line, or the circuit breaker itself.

Why would GFCI outlet keep tripping?

If the GFCI detects a ground fault leakage of 5mA it will trip. This leakage is caused by a hot wire touching the ground somewhere on the electrical line such as an appliance or even the outlet itself. This can be caused by water, wires touching, dust or debris, etc.

How can you tell if a GFCI outlet is bad?

How to Tell If a GFCI Is Bad. When a GFCI trips, it won’t supply power, so your hair dryer or power saw won’t work, and if a tripped GFCI is at the beginning of a circuit, it will cut power to the entire circuit, so other outlets and lights on the circuit won’t work either.

Why would a GFCI trip with no load on it?

A Loose Wire in an Outlet





This wiring problem can be maddening. In short, one of your outlets has a loose wire that is causing your breaker to trip and will continue to do so until it’s replaced. This is a somewhat common problem if you have an outlet with a GFCI (Ground-Fault Circuit Interrupter).

Why does my garage keep tripping?

A short circuit should always cause a breaker to trip or a fuse to blow and may also cause sparks, popping sounds, or smoke. It may also be caused by issues like loose connections, a slipped wire, or even from damage caused by animals (mice or squirrels) chewing on wires.

What does it mean when GFCI trips?

If the GFCI’s internal current transformer senses more than a 4-5 milliamp loss, it instantly shuts down the outlet and any outlets it feeds to prevent accidental electrocution. Most often, when a GFCI “trips” it is the result of a faulty appliance plugged into the outlet or an outlet down circuit.

How long should a GFCI outlet last?

between 7-10 years



GFCI outlets last between 7-10 years but can sometimes fail after only 5 years. Since GFCIs are one of the most important safety features in your home, it’s important to check your GFCIs monthly and every home should have its GFCIs tested and replaced if necessary every 7-10 years.

Can an overload trip a GFCI?

Overloads don’t trip a GFCI.

If there was an overload, it would trip the actual circuit breaker. Since this is a GFCI/receptacle (as opposed to a GFCI/breaker) and the GFCI trips, that is a GFCI problem – 100% – and not an overcurrent situation.

Can a bad breaker cause a GFCI to trip?



Hi Amps – When installed a GFCI breaker carries a set amount of amperes which may sometimes be too low to facilitate some electrical loads and because of this tripping can occur. Faulty Breaker – Another very common possibility that will initiate a GFCI breaker tripping is a faulty breaker.