How do you open a thermostatic cartridge?

Quote from the video:
Quote from Youtube video: So you don't lose anything step 2 disassembled the unit remove the temperature controller with an allen key then use a screwdriver to pop off the circlip.

How do I change a thermostatic shower cartridge?





Quote from the video:
Quote from Youtube video: Insert the cartridge into the valve housing and tighten using the adjustable spanner. Until it is tight tighten the grub screw using the hex.

How do you open a thermostatic shower door?

Quote from the video:
Quote from Youtube video: You will need to remove the handle prong to access the grub screw on the thermostatic. Handle remove the temperature stop ring with the shower in the on position replace.

How do you remove the cartridge from a bar mixer shower?

Quote from the video:
Quote from Youtube video: Most simple and most obvious the cartridge itself just screws into place. And so the catcher just unscrews.

How do you change a concealed thermostatic shower valve?

Quote from the video:
Quote from Youtube video: Handle. Remove the temperature stop ring remove the faceplates retaining rings and the faceplate. Itself.

How do you remove a Grohe thermostatic cartridge?





Quote from the video:
Quote from Youtube video: You when removing the cartridge start with loosening the cartridge nut with the tool just break it loose.

How do I know what shower cartridge I have?

Quote from the video:
Quote from Youtube video: Off and then you can look behind the plate to see if there's a sticker in here that has the manufacturer.

Why do thermostatic shower cartridges fail?

There are several reasons why the cartridge may have failed; the number one cause is an in-balance in water pressure between the mains cold pressure and the heated hot water(and this is very common). This constant in-balance between the two will cause damage to the cartridge which is housed within the valve.

How do you remove a shower faceplate?

Quote from the video:
Quote from Youtube video: And make sure they handle the plate on the new kit will fit in its place take off the handle there's usually a set screw underneath the handle that you can access and unscrew the screws so the handle.

How do you replace a flow cartridge?



Quote from the video:
Quote from Youtube video: And it goes then you don't need to worry about orientation. Just just pops. Straight. Once it's an attained it's really just fit the refit the blast. Bush. And then the handle.

How do you disassemble a mixer shower?

Quote from the video:
Quote from Youtube video: And then slowly turn it anti-clockwise to effectively open up and release the actual mixer. And shower unit.

How do I change the cartridge in my mixer tap?

Quote from the video:
Quote from Youtube video: To fit the replacement cartridge it needs to be located in the body of the tap and rotated clockwise to a position where it's hand tight.

How do you change a thermostatic crosswater cartridge?



Quote from the video:
Quote from Youtube video: Process it will be necessary to isolate at an alternative point in the system for both hot and cold water supplies. And repeat the isolation. Process loosen the grub screw using the hex.

How do I know if my shower cartridge is bad?

There are a few ways to tell if your shower cartridge has gone bad:

  1. Dripping or running water when you turn your shower off (most common)
  2. Difficulty turning the shower handle, which worsens over time.
  3. Shower handle gets stuck or “slips” and doesn’t turn on the water.


How do you remove a shower valve cover?

Using a flat-blade screwdriver, gently pry the plug button from the front of the valve trim. Using a Phillips screwdriver, unthread the screw and remove the handle and adaptor from the valve stem. If applicable, rotate the cover counterclockwise to remove. Slide the sleeve off the valve.

How do you remove a shower stem?



Quote from the video:
Quote from Youtube video: You have to pry off the index from the end a good tip is to make sure you have something in the tub drain. So you don't drop it right down the drain.

How do you open a shower head?

Quote from the video:
Quote from Youtube video: The first method is if the front just unscrews so basically turning it counterclockwise. It would unscrew.

How do I remove my mixer shower handle?

Quote from the video:
Quote from Youtube video: And then you can remove. This body and then you can remove the nut that's holding the cartridge to the valve. And then you can do the seeds.