How do you change a high limit thermostat on a dryer?

Quote from the video:
Quote from Youtube video: You can use the belt to help lift out the drum. Note the orientation of the wires connected to the high limit thermostat then disconnect them unthread the mounting screws to detach the old thermostat.

Is a thermal fuse the same as a high limit thermostat?





The thermal cut-off (fuse) is meant to trip at a higher temperature than that of a high limit thermostat. This is a one time use fuse, so when it does trip, you must replace it. The hi-limit thermostat acts as a safety mechanism that keeps the dryer from overheating.

How do you test a high limit thermostat?

Quote from the video:
Quote from Youtube video: Off you may need to use a needle nose pliers. Now turn your multimeter to the continuity setting and tap the two probes together to test if there is continuity the meter will beep.

How do you change a thermostat on a Kenmore dryer?

Quote from the video:
Quote from Youtube video: Next disconnect all four wires from the old cycling thermostat remove the mounting screw. And slide the thermostat out of the slot. Install the new cycling thermostat.

What happens when a dryer thermostat fails?

If the dryer does heat up, a bad dryer thermostat can result in loss of temperature control. If you have a faulty dryer thermostat, the dryer may keep the heat on for too long, causing the dryer to get too hot. If the cycling thermostat is defective, the dryer will not heat up.

How do you bypass a thermostat on a dryer?





The thermal fuse will look like a thin strip of white plastic with a wire coming out of each end. In order to bypass the thermal fuse, use electrical tape to tape the two ends together. The thermal fuse will then be bypassed. Turn the dryer on to a heat cycle for no more than 90 seconds.

What is a dryer high limit thermostat?

A dryer high-limit thermostat (High Limit Thermostat, Hi-Limit Thermostat, Dryer High-Limit Thermostat) is a switch that is actuated by temperature change. This high limit thermostat acts as a safety mechanism to keep the dryer from overheating. If your thermostat is malfunctioning, your dryer may not heat.

How do I reset my dryer thermostat?

Many dryers are equipped with a reset button on the control panel. If the motor won’t run, let the dryer cool for about ten minutes. Then push the reset button. If there are no problems with the motor, switches, or electrical system, this should restart the dryer.

How many thermostats does a Kenmore dryer have?

On the back, the heating element housing on the right has two thermostats one upper and one lower (there are two other dryer thermostats on the far left side of the back of the dryer). To check any thermostat, simply use a voltmeter continuity function to check for a break between thermostast terminals.

How do you check a Kenmore dryer thermostat?



Quote from the video:
Quote from Youtube video: So two things we're going to check right here is going to be the actual heater and then the limit thermostat that controls. That. So you want to go ahead and set your voltmeter. Domes.

Why is my Kenmore dryer overheating?

Most dryers have a felt seal at the front and rear of the drum to prevent heat from escaping the drum. If the seal is worn out or missing, the heat will not be drawn through the drum properly, causing the dryer to get too hot. Check the drum seal to ensure that it is creating a reliable seal around the drum.