You simply need to convert the outlet into a junction box :
- Flip the circuit breaker off.
- Unscrew the hots, neutrals, and ground from the outlet and remove the outlet.
- Splice the hot, neutral, and ground from both sides (charge and load) and put wire nuts on.
- Cover the box with a junction box lid.
- Flip the circuit back on.
How do I remove an electrical outlet permanently?
Check the Outlet
- Check the Outlet. Outlets that feel hot or have produced sparks, smoke or a burning smell are a fire hazard. …
- Turn Off the Power. …
- Remove the Wall Plate. …
- Double Check Wires for Power. …
- Determine the Receptacle Size. …
- Snip and Restrip Damaged Wire Ends. …
- Install the New Receptacle.
How do I cover an unused electrical outlet?
Use a box cover to fully cover the outlet. Box covers cover the entire outlet panel to prevent children or pets from accidental electrocution. Measure your outlet’s length and width, and choose a cover that matches the outlet’s dimensions. Find box covers at most hardware or home improvement stores.
Can I remove an electrical outlet?
Quote from the video:
Quote from Youtube video: If they're attached on the side by screws loosen the screws with the screwdriver. If they're inserted in holes in the back place the screwdriver.
How do you cap a wire after removing an outlet?
In many cases, though, it’s easier to simply cut the wires with wire snips. Screw a wire cap tightly onto each wire you remove and push it into the back of the electrical box. Before you remove the outlet itself, it’s always a good idea to check the terminals with a voltage tester before you start working.
Is it safe to cover an outlet?
One roll should cover every low-lying outlet in the house. Covering them with tape makes them inaccessible and way less appealing to a curious toddler. You can also use duct tape if you want it to stick a little better; however, duct tape could leave a sticky residue on your outlets and walls.
Can an outlet catch fire with nothing plugged in?
An outlet can also catch fire even if nothing is plugged in. This can occur in homes that use aluminum wiring. If your house was built more than 50 years ago, chances are, it was built with aluminum wiring. Aluminum wires are more likely to catch fire, because aluminum is softer and expands more than copper.
Can you leave an outlet without a cover?
Don’t: Leave Outlets without Cover Plates
Even if you don’t think certain outlets in the apartment work, you should never leave outlets exposed without the cover plates in place. Cover plates are simple to replace, as most fit a standard size and require only two screws to keep in place.
