Pour lots of hair rinse mixed with water on both ends and make sure all pipe is lubed. Then wrap the wire end in some round object like a piece of pipe to pull, apply pulling force in slow constant intervals for approximately 5 seconds each. If you feel snapping you are pulling too hard and the cable will snap.

How do you loosen tight coaxial cable?

Place the open end of a 7/16-inch cable wrench onto the nut of the F-connector. Push the handle of the cable wrench gently counterclockwise to loosen the nut. Apply additional penetrating oil to the connection if the nut will not move under gentle pressure. Allow the oil to sit on the connection for one hour.

How do you make a coaxial cable come off?





Quote from the video:
Quote from Youtube video: The first step is you take your piece of coaxial cable. Put the stripping tool over the end of the cable. Give it a twist. And strip the cable back.

Can you use a wrench on a coaxial cable?

The 7/16″ wrench should be in every home enthusiast’s toolkit. It’s the perfect size for coax cable connections. Don’t rely on pliers that can tear at the sides of the connector, and only use an adjustable (crescent) wrench in a pinch — it’s probably too wide to get a good hold on that connection and it can slip too.

Why are coaxial cables so stiff?

The nature of Coaxial cables is that they are all stiff. The intention is to maintain the spacing between the core and the screen so the permeability stays the the same. This means the geometry of a cable should stay the same along it’s entire length.

How do you strip coax cable without tools?

Quote from the video:
Quote from Youtube video: Around the dielectric. And make a series of cuts. Turn. Again we're going to do is we're just going to rotate. This. And we can see the removes quite neatly.

How do you use a coax stripping tool?





Quote from the video:
Quote from Youtube video: So you are able to strip the cable at two designed depths to use this tool clamp it onto the coax cable like so and then rotate around ensure that you have the cable inserted.

How do you remove a reuse coax connector?

Quote from the video:
Quote from Youtube video: So I go ahead and take unscrew this and send it down the coax. If there is no connector on the other end I just go ahead and pull it off.

How do you strip a cable?

Quote from the video:
Quote from Youtube video: So that's one big advantage over the scissors. And once you squeeze it it's a pretty easy job to strip the wire. And you end up with a decent. Result. Now we're starting to get a lot more advanced.

Can you use pliers to strip wire?

Quote from the video:
Quote from Youtube video: But squeeze them just a bit until you feel a little bit of pressure and rotate. The wire. So continue rotating the wire. And use those blades to simply cut the skin or the outside portion.

How do you strip PVC cable?



Quote from the video:
Quote from Youtube video: Cut I usually make it look incredibly easy and it isn't to get it in the right position so using that as the line on the cable put it in the center.

Which tool is used for the simplest method of skinning wire?

A wire stripper is a small, hand-held device used to strip the electrical insulation from electric wires.

How do you make a wire stripping tool?

Quote from the video:
Quote from Youtube video: This here is my homemade wire stripper. It is I used a hacksaw to cut these lines. And then I used different size drill bits to make the different holes to fit each thickness in gauge wire.

What is a wire puller?



Definition of wire-puller



: one who uses secret or underhanded means to influence the acts of a person or organization.