What do you do if your toilet doesn’t have a shut off valve?
Quote from the video:
Quote from Youtube video: One i'll take my handy dandy needle nose and that has a wire cutter on it. I'm going to cut roughly. About a foot this little bitty wire is going to save possibly your floor.
Do all toilets have a shut off valve?
Toilets, just like other plumbing fixtures, come with a shutoff valve. The shutoff valve is mostly located in the toilet’s water supply line. It’s necessary for every toilet to have its dedicated shutoff valve for convenience.
How do you replace a water valve without turning off water?
First, open the valve, then cut the supply line. When you cut the supply line, use the shark bite ball valve in the open position. Put PVC glue on the pipe and push the “open valve” on the pipe. There is PVC glue that can be used to stop water leakage.
How do you install a shut off valve on an existing water line?
- Identify the Existing Valve. Determine whether the valve to be replaced is connected to the pipe using solder, a compression fitting or threaded fitting. …
- Remove the Old Valve. Shut the water off to the fixture. …
- Prep the Pipe. …
- Install the Valve. …
- Attach Supply Lines. …
- Check for Leaks.
- Turn off the water supply to the PVC piping by securing the main water line into the house. …
- Cut out a small portion of the PVC pipe with a hacksaw. …
- Insert the shutoff valve onto the PVC piping. …
- Test the valve.
- Turn off the main water valve to the house. …
- Cut the plastic pipes 1/2 inch from each end of the valve that’s being replaced, using a handsaw. …
- Use a rag to remove any moisture from the ends of the pipes. …
- Apply PVC primer around the male end of the connector.
- Arrange to Have the Water Shut Down at the Street. …
- Prepare the Work Area. …
- Turn the Water Off. …
- Drain the Water Line. …
- Remove the Old Valve. …
- Clean the Pipe and Fittings. …
- Solder the Inlet Side of the Valve. …
- Test the Valve for Leaks.
- Remove the Toilet Fill Valve. To remove the toilet fill valve, first disconnect the water supply tube attached to the bottom of the fill valve tailpiece, using channel-type pliers or an adjustable wrench. …
- Prepare the New Fill Valve. …
- Install the New Fill Valve. …
- Connect and Make Adjustments to the Fill Valve.
Is it OK to turn off water supply to toilet?
It’s recommended you shut off your water when: A pipe, fixture, or appliance is leaking. The toilet is running constantly even after adjusting the parts in the tank.
Where is the shut off valve on a toilet?
Toilet: Look under the toilet, against the wall, for the flexible metal tubing. Turn the handle clockwise until the handle stops. Do not force, as most shut off valve handles are plastic and can easily break.
How do you install a shut off valve on an existing PVC pipe?
You only need a few tools and no real plumbing experience.
How do you change a shut off valve on a PVC pipe?
How to Replace Plastic Plumbing Shutoff Valves
How do you change a water shut off valve?
Replacing Solder Main Water Shutoff Valves
How do you replace a toilet fill valve?
Instructions
Is it hard to replace a toilet fill valve?
However, the good news is that replacing your toilet fill valve is something any homeowner can do. It does not take a lot of experience with plumbing or a lot of time. However, you do need a few parts, a couple of tools, and a little bit of effort.
What is toilet fill valve?
The fill valve (sometimes referred to as a ballcock) brings water into the tank after the toilet is flushed and stays on until the tank refills. Any time water exits the tank (such as when a flapper is leaking), the fill valve will turn on in order to maintain the water level.
