https://youtu.be/UAeKTlieYhw
How do you wire a remote relay?
Quote from the video:
Quote from Youtube video: You'll see see if I can get a good angle see how these two are flat everything's. These two are flat and this one's still on that same angle as the side pins that's your output wire all right.
How do I connect to QwikSwitch?
Setup Phone as hotspot to (tether) with the below parameters or change Router SSID and PASSWORD to: SSID = QwikSwitch (please note capital Q and S) PASSWORD = Wifi Bridge 12 digit ID as seen on the back of the Wifi Bridge sticker. Reboot the wifi bridge after setup to ensure it has connected to the router.
How does a 3 pin relay work?
Quote from the video:
Quote from Youtube video: It supplies power to the suit to the control circuit. And once that's energized it causes a switch and also supplies power to the 87 pen which goes to your accessory.
How do you wire an audio relay?
Quote from the video:
Quote from Youtube video: Ground link terminals here on the ground. Side. So those connections aren't made yet but that's what will connect up to the battery in the front of the vehicle. And the ground of the vehicle.
How do you use a 12V relay?
Quote from the video:
Quote from Youtube video: And it's pretty simple so terminal 30 it's going to go over here to your battery positive so to your 12-volt battery use one wire run it from terminal 30 to the battery.
What is WIFI Bridge Huawei?
Wi-Fi bridge is a type of portable hotspot feature on Huawei smartphones that allows you to share your wireless connection with another phone, tablet, computer or some other device that supports the 802.11 b/g/n standard. It is equal to Samsung’s Wi-Fi Sharing.
What voltage is AMP turn on wire?
12+ volts
While in the ON position, there should be 12+ volts at the remote turn on wire. If you have 12+ volts while the ignition is OFF, the remote turn on wire is connected to constant power.
How do you wire a negative switch relay?
Quote from the video:
Quote from Youtube video: Load wire and that would go to one side of the switch the switching terminals. And then the other side would go to a constant 12-volt.
What is a SPDT relay?
The SPDT Relay(30A) is a high quality Single Pole Double Throw Relay(SPDT). The Relay consists of a coil, 1 common terminal, 1 normally closed terminal, and one normally open terminal. When the coil of the relay is at rest (not energized), the common terminal and the normally closed terminal have continuity.
What is SPDT and DPDT?
“SPDT” stands for “single pole double throw,” while “DPDT” stands for “double pole double throw.” Both terms are varieties of switches. A switch, in a mechanical and electrical setting, is a control device that is used to establish or interrupt the flow of power or electricity into a circuit.
How do DPDT relays work?
DPDT stands for double-pole double-throw relay which is an electromagnetic device used to separate two circuits electrically and connect them magnetically. They are often used to interface an electronic circuit, which works at a low voltage to an electrical circuit which works at a high voltage.
