How do you finish tile next to drywall?

Quote from the video:
Quote from Youtube video: So there's a couple ways to waterproof. This you can either use sheet membrane. Like this rss sheet membrane or kerdi. And you would just cover the transition.

How do you attach bullnose tile to drywall?





Quote from the video:
Quote from Youtube video: Like the bottom two-thirds of the tile. You don't want to set it down with the bottom like this. And then smash it up against the wall. Give it a good wiggle.

How do you finish the outside edge of a tile shower?

Quote from the video:
Quote from Youtube video: Done is found these strips that can be added to the edge of the tile to hide that cut edge or hide the end of the edge of the tile.

How do you finish tile on the edge of a bathtub?

Quote from the video:
Quote from Youtube video: Pressure get it right tight into the corner. The next one goes in the same way except I'm going to use another one of the spacers between the tiles.

What should I put between drywall and tile?

The best product to use under tile in wet areas is cement board. This is similar to drywall in that it comes in sheets, but cement board will not develop mold or deteriorate when exposed to water.

How do you finish drywall where you meet the shower?





Quote from the video:
Quote from Youtube video: And then run it over the top and run it up against the top not a bad option the other option of course is to just mud it and then run mesh tape over the top mud it again with a skim coat and sand it.

How do you install bullnose tile edging trim?

Quote from the video:
Quote from Youtube video: First fit the tile trim into a bed of adhesive on the bottom of the window cutting to size with a suitable saw miter the corners for the tightest. Finish. Then measure cut and fix the tiles.

Do you use spacers for bullnose tile?

Press the bullnose onto the wall at a slight angle and twist it into place. Use tile spacers if necessary to help line up the nosing tiles with the field tiles.

How do you install a bullnose corner?

Quote from the video:
Quote from Youtube video: Run the bead through the hopper and install on the corner. Adjust the bead as needed so that it is sitting evenly on the corner. Pressure the entire length of the bead.

How do you use Bullnose tile trim?



Quote from the video:
Quote from Youtube video: Now bullnose has been around for thousands of years and what that really means is it's a trim piece we use this trim piece on the side of ceramic. And porcelain tile. And this is actually stone.

How do you add tile trim after tiling?

Quote from the video:
Quote from Youtube video: Make sure you have allowances of 45 degree angles on both sides. Now that we have our measurements it's time to cut our tile trim but just remember it's just like making a picture frame.

Can you add tile edge trim after tiling?

Are you thinking about tackling a tiling project, but are struggling to figure out how to install tile edge trim after tiling? No worries! It’s a lot easier than you might think.

How do you caulk tile edges?



Quote from the video:
Quote from Youtube video: So you can wet your finger wet a tool. And then you're going to want to smooth. It right after you apply it as a rule of thumb. We like to remove the tape immediately.