How do you cap off a copper refrigerator water line?

Quote from the video:
Quote from Youtube video: So we'll take the black piece of plastic. Set it right inside the pipe. And just press it on. And you hear a definite click and you can feel it hit back in here.

How do I temporarily cap my fridge water line?





Unscrew the connector using locking pliers and purchase a cap or plug that will fit it. It’s easy to install the cap — just screw it on. Once it’s tight, turn on the water to make sure it doesn’t leak, then turn the water off again, and you’re ready to plug in the refrigerator and push it back against the wall.

How do you disconnect a refrigerator water line without a valve?

Quote from the video:
Quote from Youtube video: And channel locks you guys usually it's probably you probably just need two channel locks i didn't have two on me right away so i just took a pipe wrench.

Can you disconnect water from fridge?

If the ice maker is connected to the water in the refrigerator door, you need to remove the door first to access the water connection. Disconnect the tubing in the door, then drain the water line over a bucket.

Can you cap off a saddle valve?

If you don’t want to hassle with removing the saddle AND the tubing coming off the saddle is copper and you just want to permanently but reliably cap it off, cut the copper coming off the saddle at least 6 inches away from the pipe and then solder on a cap rather than use a compression fitting.

How do you cap off plumbing?





Instructions

  1. Shut Off the Water. Shut off the water supply to the house. …
  2. Cut Off the Pipes. Cut off the water pipes, using a tubing cutter if you have enough room to rotate the tool around the pipe. …
  3. Clean the Pipe Ends. Clean the end of each cut pipe with a rag. …
  4. Cap the Pipes. …
  5. Test the Capped Fittings.

Feb 24, 2022

How do you stop a refrigerator from leaking water?

If you need to fix a refrigerator water line leak in copper tubing, the steps are basically the same as repairing a plastic water line. Identify the damaged length of line, remove it with a tubing cutter, and replace it with copper tubing secured with brass unions at each end of the fix.