Is it OK to extend a washing machine drain hose?
You can buy supply hoses in lengths up to 96 inches, which you can attach to your existing hoses with 3/4-inch hose thread connectors. Lengthening the drain hose isn’t difficult, because you can buy a drain hose extension that simply clamps onto the end of your existing hose.
How do I extend the waste water pipe in my washing machine?
Quote from Youtube video: So one easy thing to do is to get one of these two-way connectors. You just pop it in there and get some more pipe which i've already got that's going to the spigot.
Can you extend washing machine inlet pipe?
No need to remove the original Inlet Hose Pipe and this can be fitted as extension to the existing pipe.
How far can a washer be from the drain?
For new Top Load washers, the drain hose should be no more than 5″ down into the drain pipe. For Front Load washers, the drain hose should be no more than 7″ down into the drain pipe.
Can you connect 2 washing machine hoses together?
Hooking up two washing machine hoses to create a longer hose connection requires a coupler available at appliance repair stores and gardening centers.
How long should the drain hose be on a washing machine?
It is best if your drain hose is 28” high from the ground. For a top load washing machine, 5” of the hose will go inside the drain pipe. And for front load machines, the length should be 7”.
How do you extend a drain?
Quote from the video:
Quote from Youtube video: So you need the proper washer insert the retention nut. And the nylon washer. And loosen up there p-trap. And install the extension tail piece. And stole another retention nut.
How do you connect a dishwasher to a washing machine to one waste pipe?
There are two main ways in which this can be done:
- Double-spigot trap: Your waste is likely to leave your property through a ‘U bend’ similar to that on your toilet and beneath a sink. …
- Splitter: The easier option, however, is where you leave your existing waste in place and connect the two wastes to a ‘splitter’.
How do you route a washing machine drain hose?
Quote from the video:
Quote from Youtube video: If the top of the drain pipe or siphon break is located above the maximum height allowed your washer will not be able to pump out water adequately. As a result the water may flow back into the washer.
Does a washing machine drain need a trap?
If they omit the trap and vent, it’s a mistake that can cause problems on two counts. The lack of a P-trap exposes the area to sewer fumes and the lack of venting will cause the drain to run sluggishly and overflow. Washers, like all fixtures, need a trap.
Does a washing machine drain line need to be vented?
All plumbing fixtures—including washing machines—must be vented. Improperly vented drains can be sluggish and noisy, and can emit hazardous fumes. Properly vented drains allow the P-trap to do its job: prevent sewer gases from escaping into your home.
How far can a washer be from a vent stack?
4 feet
It prevents the possibility of a vacuum forming which could affect the water draining from your washing machine. If your washing machine is more than 4 feet from the vent stack, you should install a vent to make sure there’s enough room for the machine to drain properly.
Can a washer and toilet share the same drain?
Some buildings have multiple waste lines that are connected to different appliances. However, if you’ve already taken note of the fact that your toilet gurgles whenever the washer drains, they’re definitely using the same system. That means that they also share the same vent stack.
Can a washer and sink share a drain?
If you’re joining a washing machine and kitchen sink on the same drain, you may be able to vent them both with a single vent if they are close enough together. If not, you can connect their separate vents before they tie into the main vent stack.
Why does my sink gurgle when washing machine drains?
The gurgling sound from your kitchen sink results from the vent being blocked. So when the washing machine water is draining, the air in the vent will be pushed by the water, and because the vent is already blocked, the air will escape via the sink and thus the gurgling sound.
Why does my washing machine drain into the sink?
A washing machine backing up into the kitchen sink can be caused by either a clogged drain or a vent problem. When a kitchen sink is clogged and backing up the problem can often be solved with a plunger.
