https://youtu.be/o84JillX_bA
How do you take apart metal soffit?
Removing Aluminum Soffit Panels
- Remove any guttering suspended directly in front of the opening to the aluminum soffit panels. …
- Pry off the nails with a pry bar or unscrew the screws holding the fascia covering in place, instructs This Old House. …
- Remove the screws holding the soffit panels to the underside of the roof.
How do you remove aluminum soffit without damaging it?
Assuming you have metal fascia as well, gently remove the nails securing a section of it where you need to work. Flex it out, then remove the hidden nails holding the soffit. Lower the soffit panels slightly by tilting them downward, and slide them past the fascia individually. Reinstallation is the reverse.
How do you remove a section of soffit?
Step-By-Step Guide To Remove Vinyl Soffit
- Step 1: Gather your tools and essentials. For this project, you will require a few basic tools to get the job done. …
- Step 2: Position the ladder. …
- Step 3: Unlock one edge of the soffit. …
- Step 4: Move the soffit to unlock the opposite edge. …
- Step 5: Push to release the panel.
How do you remove aluminum soffit from under roof?
Cut aluminum fascia, soffit and drip edge to width by scoring it with a sharp utility knife. Guide the score with a straightedge for flat work. Then either peel back the material or bend it back and forth until it snaps off. You could use metal snips, but this method yields a cleaner, straighter cut.
How do you use a soffit removal tool?
Quote from the video:
Quote from Youtube video: You don't have to start at one end and take them all down you just reach up in between your carriers with this tool this is what we call a zip tool it's what we use to unhook vinyl siding.
How do you replace aluminum soffit?
Quote from the video:
Quote from Youtube video: Under the old piece on the right hand side and over the old piece on the left hand side. And then make sure your soffit is tucked under that lip.
What is under a soffit?
What is Fascia? If ‘soffit’ is the horizontal base area that covers the eaves, ‘fascia’ is the vertical. Fascia board is placed on the ends of the eave rafters and under the roof shingle or tile.
How is soffit attached?
In situations where the soffit panel will be attached at the wood fascia board and then covered with an aluminum fascia cover (Fig. 66), each soffit panel should be fastened through the nail hem and either into the wood fascia or into a wood shim using nails, screws, or staples.
