Try gently pulling upward while turning. If your stopper does not have a visible screw set on the knob, but does not seem to unscrew, lift the stopper up and turn, looking for a small screw. Use a standard flathead screwdriver or an Allen wrench (hex key) to loosen the set screw.
How do you remove a stubborn tub stopper?
Hold the body of the stopper in place with one hand and with the other hand unscrew the knob by turning it counter-clockwise. If the knob will not unscrew, then wrap the rag around the knob and use the pliers to help remove the knob.
How do you remove the stopper?
Push and Pull
- With the stopper in the open position, unscrew the knob from the stopper base.
- Push the stopper closed to reveal the center post.
- Use pliers or a flat-head screwdriver in the center to loosen the slotted screw inside the center post in a counterclockwise direction.
- Lift the stopper from the drain.
Why won’t my sink stopper came out?
There are a few reasons why this part of your sink might not be working. The part of the pivot rod that connects to the drain stopper may have rusted or broken off, or the drain stopper itself might be broken so that the pivot rod can’t actually pull the stopper down.
How do you remove a tub stopper without screws?
If your stopper does not have a visible screw set on the knob, but does not seem to unscrew, lift the stopper up and turn, looking for a small screw. Use a standard flathead screwdriver or an Allen wrench (hex key) to loosen the set screw. You shouldn’t have to remove the screw entirely to remove the stopper.
How do you get a push plug out?
Open the stopper all the way and grasp the head with one hand while you grasp the shaft underneath it with a pair of adjustable joint pliers. Turn the head counterclockwise. If the shaft doesn’t turn, continue turning the head until it disengages from the shaft.
How do I disassemble a sink drain?
Steps for Removing a Sink Drain
- Shut off the water. Before you remove your sink drain, you will want to shut off the water. …
- Disconnect the water supply line. …
- Remove the P-trap. …
- Remove the pop-up sink drain. …
- Remove the tailpiece. …
- Remove clips and cut away sealant. …
- Remove sink. …
- Disconnect the backsplash.
How do you remove the drain stopper from a kitchen sink?
If the stopper is flat and will not pop up, put a drop of super glue on the corner of a note card and glue the card to the stopper. After a few seconds, lift the card and it will pull up the stopper. I just did this and it worked like a charm.
How do you remove a stopper from a sink without a rod?
In this case, you can sometimes skip removing the stopper altogether.
- Place a bucket under the P-trap.
- Unscrew the connectors on each end of the P-trap. Use pliers if they’re tight.
- Pull out the P-trap and look for clogs. …
- Check the P-trap itself for clogs. …
- Reassemble the P-trap and sink stopper if applicable.
How do you remove a sink trap plug?
Use an adjustable wrench or adjustable pliers to unscrew the clean-out plug from a P-trap. Place a bucket under the trap to catch the water that will spill out when you remove the plug. Turn the plug counterclockwise to remove it, install the replacement, and turn it clockwise to tighten it.
