ANSWER. ANSWER – No there should not be a gap between the top of the bathtub flange and the backer board on the wall. There should be a moisture barrier behind the backer board that is installed in a weather lapping manner starting at the tub flange working up the wall.
How close should drywall be to the tub?
Typically, the water-resistant drywall is extended 4 to 6 inches beyond the front vertical edge of the bathtub or above the shower head if you’re installing a shower and tub combo, where it will meet the standard-type drywall covering the balance of the bathroom walls.
How much space should be between tub and wall?
Plan a clear floor space of at least 30 inches from the front edge of all fixtures (lavatory, toilet, bidet, tub, and shower) to any opposite bath fixture, wall, or obstacle. Code Requirements: A minimum space of 21 inches must be planned in front of the lavatory, toilet, bidet, and tub.
How do you fill gap between tub and drywall?
Quote from Youtube video: Everything needs something to bond to mix up some 20-minute speed set joint compound. And press it into the gap keeping it flush with the drywall.
What goes between tub and wall?
Rigid air barrier materials for use behind showers and tubs include fiber-cement, fiber-reinforced gypsum, glass mat gypsum, or fiber mat-reinforced cementitious backer panels.
Can you put drywall around a tub?
Quote from the video:
Quote from Youtube video: And then as the tub flange can flares out away from the wall. I'm going to change it down to a quarter inch piece of sheetrock. I've inserted these little shims. So that it's closer to a quarter inch.
Does drywall go over tub lip?
Drywall will typically work just fine for a bathtub surround, but more waterproof materials are preferred. A concrete backer board is an excellent water-resistant option and is probably the most popular choice for bathrooms.
How far should tub filler be from tub?
Tub Height – most tubs are between 22″ – 28″ tall. The water exit point of the spout of the tub filler should be about 6 inches above the tub. Any higher and there may be some unwanted water splashing on the side of the tub filler.
Is it better to caulk or grout around tub?
Since you are joining two different materials together, you should use caulk in the space where the floor tile and tub meet. Grout is not flexible, so it’s not the best material for the job, while caulk allows for movement and also provides a better sealant.
What to do with the space at the end of the bath?
Start simple if you want to find a way to use the space at the end of your tub. Generally, people use this added space to hold bath/shower products, like soap, shampoo, conditioner, lotions, and oils. Additionally, you can use the section at the end of your bathtub to place candles or incense on.
How do you edge a bathtub?
Quote from the video:
Quote from Youtube video: You'll need to replace it. First strip off the old silicone or sealant. You can use a specialist sealant remover or carefully. Cut away using a craft knife. And then pull off the old seal.
Should I insulate around my bathtub?
When the time comes to switch out an old bathtub, insulate underneath the new one to boost its heat-retaining properties. While bathtub materials vary in how well they keep bathwater warm, it’s easy and inexpensive to increase any bathtub’s heat-retaining properties with insulation.
What goes around a bathtub?
For caulking around a bathtub, Tom recommends using anything that is 100% silicone. In the segment, he used 100% Silicone Sealant in White, which is manufactured by Gorilla Glue.
How do you drywall around a bathtub?
Quote from the video:
Quote from Youtube video: So you're going to need the caulk. And then really all you need is just a stapler. And this stapler is just going to be you're just going to put staples along here into the drywall.
How far should wall extend past bathtub?
Plan to extend the tile 2 or 3 in. beyond the tub and to leave at least a half tile along the wall if possible. Don’t stop tile even with the end of the tub. This leaves the walls along the front of the tub vulnerable to water damage, and doesn’t look as finished as tile extending to the floor.
