How do you install a pendant light in a junction box?
Quote from the video:
Quote from Youtube video: You can also cut the hole manually with a jab saw I took the drywall circle out and put the new electrical sealing box in place.
How do you attach a light fixture junction box to a wall if there is no stud?
Quote from the video:
Quote from Youtube video: After we have our braces in between our studs we're going to take our hammer and right on the sides. There's some spikes we're just going to knock that into the studs.
Can I hang a pendant light without hardwiring?
Quote from the video:
Quote from Youtube video: And you can just hang your light on it like. So if you don't have a wood joist and it is just in the plaster.
How do you hide a junction box in the ceiling?
Quote from the video:
Quote from Youtube video: And a plastic mounting bracket. Next you can go ahead and start your screws. You can just start them with your fingers at first and get them so they are just. Starting to thread.
How do I install pendant lights without attic access?
Quote from the video:
Quote from Youtube video: I would go in and make a hole at the top of the wall. Make a hole in the ceiling. And that would allow me to get into this bay. And then to grab the wiring.
How do you install a pendant light without an existing wire?
Quote from the video:
Quote from Youtube video: Up through the wall with the romex cable and then i need to place the light fixture in the center of the room. So i just measured putting painters tape in the center of the room.
How do you center an off center ceiling light without moving the junction box?
Quote from the video:
Quote from Youtube video: I attached the mounting plate and filled the screw holes with spackle before attaching the light. Now the light is centered over the table in both directions.
How do you add a light fixture to an existing circuit?
Quote from the video:
Quote from Youtube video: You always want to go in the clockwise. Direction so when you're tightening the screw. Down the wire would have a tendency to pull around the screw.
How do you hang a pendant light on a ceiling?
Instructions
- Remove the Old Light. Using an appropriate screwdriver, remove the screws holding the light casing. …
- Note and Mark the Wire Connections. …
- Disconnect the Wires. …
- Install the Mounting Bracket. …
- Check the Hanging Height. …
- Attach the Wires. …
- Close Up the Junction Box. …
- Test the Light.
