How do you join round ductwork together?

Quote from the video:
Quote from Youtube video: So once you feel one side collapse in you're going to prep put pressure on that side with your body and then guide the rest end. Until you hear it snap.

How do you connect round duct to round duct?





Quote from the video:
Quote from Youtube video: Side is good and what we need to do is you need to crimp this side. So that we need to put an elbow on well as you can see factory.

How do you make duct fit?

Quote from the video:
Quote from Youtube video: And then you can see we have a crimp. Going all the way around the outside of the pipe you can kind of straighten it out it's always best to work with gloves if at all possible.

How do you connect duct pieces?

Quote from the video:
Quote from Youtube video: So you can go raw to raw which is ten and a half and then add two inches because remember our Ducks gonna slide in there slide in there.

How do you cut into existing round ductwork?

Quote from the video:
Quote from Youtube video: But if it's the only thing you have you can use a sawzall blade. It's just going to be a very fine tooth. And you can cut it with a sawzall.

How do you connect duct pipe to elbow?





Quote from the video:
Quote from Youtube video: Inside of inside of a sealing box. Same deal as far as the way the flange. Is supposed to go. So ever connecting to a piece of duct. It's over there and it's supplying air from this way inside.

How do you tap into an existing flexible ductwork?

Quote from the video:
Quote from Youtube video: It it just likes to slip right off you can easily just put a pan do it on it and get your pan do it gun. You know tying it down it's a lot easier than messing with the tape.

How do you replace a section of ductwork?

Quote from the video:
Quote from Youtube video: Already get the helix off. You can pull the wire out of the duct tape we'll just cut it down there and rip it right off it'll come right off we have a nice clean boot to attach to our Flex document.

Can you cut ductwork with a Sawzall?

The Ductwork SAWZALL® blade has been engineered to specifically address the unique frustrations encountered when installing ductwork take-offs. The Ductwork Sawzall® blade completely eliminates the need to carry multiple tools, lightening up your tool belt and greatly speeding up the installation process.

What do you cut ductwork with?



Cut flex duct with a utility knife or shears and tin snips. Slice the metallic outer layer and the insulation around the round flex duct with the knife or shears and lay it back to expose the coiled wires. Cut each wire with snips, taking care to make the cuts even so the cut end is straight.

How do you splice HVAC ducts?

Quote from the video:
Quote from Youtube video: Take your other. Side. Put it over the splicing collar. Like that then once you get that completely on there and you get your strap. And you tape it together then when you push this together.

Can I replace ductwork myself?

It is possible to install HVAC ductwork yourself, but it will require research and willingness to pay attention to detail. Be sure to educate yourself on the intricacies of the work so that you can be sure that you do not inhibit the airflow.