Sure you can. The length is not critical. However, care should be taken not to add elevation to the hose because the washing machine typically is not equiped with a check valve on the drain line. So if you add height to the line, when the pump shuts off a larger quantity of water will drain back into the washer.
Is my washing machine drain hose too long?
Do not install the drain hose with the end lower than 29.5 inches (75 cm) or higher than 96 inches (244 cm) above the bottom of the washer or more than 60 inches (152 cm) away from the washer. Sounds like the machine was designed with the exit of the hose well above the machine in mind.
How long can a washing machine discharge hose be?
Washing machine manuals typically specify a minimum height of 39” for the entry of the drain hose into the standpipe or faucet box, and a maximum height of 96” (8 feet).
How should a washing machine drain hose be positioned?
Typically the hose is hung from over the side, and then over the top rim of the sink. It is important to have a sizable air gap between the end of the drain hose, and the bottom of the sink. An air gap prevents backwater from ever getting sicked back into your washing machine.
What length should washing machine hoses be?
Length. Washing machine hoses vary in length from about 3 feet to 12 feet. When choosing an appropriate length for a hose, include a few extra inches of slack.
Does a washing machine drain hose need to be elevated?
Yes, the drain hose needs to be elevated and it’s always best to do so at a level that’s higher than the washing machine itself. This will prevent possible siphoning. There are also other steps you can take to ensure that you get the best drainage.
Are there different size washer hoses?
The drain hose is available in different lengths, and universal sizes are 1 to 1¼ inches in diameter. The length of the drain hose depends on how far the washer is from the stand pipe or laundry sink.
How long do braided water hoses last?
The general rule of thumb is to replace all your supply line hoses every 5 years as a preventative measure to protect your home against any potential leaks. But since braided supply lines have a rubber core, we recommend that they can be replaced every 10 years.
How long do washer rubber hoses last?
three to five years
Replace rubber washing machine hoses every three to five years.
Can a faucet supply line be too long?
Ignore the Length
The hot water may be delayed for one or two seconds, but the water pressure will be unaffected. The only downside to a longer-than-necessary flex line is that the line will bunch up beneath the sink, taking up some valuable room.
Should you use Teflon tape on washer hoses?
No Teflon tape or thread sealant should be applied to hose thread connections.
How often should you change washing machine hoses?
Replace your washing machine hoses every three to five years. Install a water hammer arrestor, which helps absorb the shock of water that increases pressure within the hose after the washing machine cycle ends. Turn off the water supply to washing machines when they aren’t in use.
Why are my washer hoses leaking?
WORN OUT WASHERS OR SEALS
A common reason for a washer water hose leak is a worn washer that sits in the water fill hose. Over time these washers get “smooshed” and allow water to pass through which causes a leak. These seals or washers can be easily replaced. Rubber Seal In Washing Machine Hose Prevents Leaks!
How do I stop my washing machine inlet hose from leaking?
Resolution
- Check the inlet hose ‘O’ ring seal for signs of damage or if this is missing.
- Check if the pipe connection is screwed on and tightened properly (tighten by hand only).
- Check if the leak is coming from the tap itself.
- Check the water supply connection to the inlet hose of the machine.
