Check to ensure the power supply is connected. Long power cables can easily be pulled from the outlet while moving the lawnmower around the lawn. Change to another outlet or extension cable to try and restore power to the lawnmower. Some extension cables can be reset via a button or switch on the side of the reel.

What causes an electric lawn mower not to start?

Your electric mower may not start due to the key not being fully engaged, the plug connections are loose, safety handles are not engaged, or an insufficient power source.

How do I fix the electric start on my lawn mower?





Quote from the video:
Quote from Youtube video: The first thing you want to do is to remove the dust cover which is just a matter of these two small screws. Then we'll remove the cable to the starter. Set that out of the way.

Does a lawn mower have a fuse?

If you think your riding lawn mower has blown a fuse, trying to locate that fuse may be the most challenging step in replacing it. While different lawn mower manufacturers have located the fuse holder in different areas of the lawn mower, the best place to start looking is near the mower’s battery, according to Sears.

Why won’t my lawn mower won’t start?

Quote from the video:
Quote from Youtube video: Starting you should inspect the spark plug for damage or wear. You can also use an ignition tester to help determine if the spark plug is defective.

How do you check an electric lawn mower switch?

Quote from the video:
Quote from Youtube video: And you can get your alligator clips on the Spade terminals. And then you can push the pedal down and try to engage that switch with the pedal. And if you hear beeping. You know for the correct sides.

How do you start a lawn mower that won’t start?





If you run into problems getting your lawnmower ready for spring, try the following:

  1. Use fresh gas. Old gasoline can cause starting difficulties. …
  2. Check the spark plug. …
  3. Use the choke. …
  4. Prime the mower. …
  5. Check the air filter. …
  6. Check the cables. …
  7. Check for water in the fuel tank.
  8. Clear the starter cord of blockages.

Why is my electric start not working?

If your electric starter does not work, check to ensure the switch is still working and its connections are secured. If the switch is broken or not connected properly, it will not start the engine when engaged. A continuity test can be performed with a multimeter to determine if the switch is faulty or not.

How do you jump a lawn mower solenoid?

How to jump a solenoid on a lawnmower, step by step

  1. Step 1: Turn the ignition switch on.
  2. Step 2: Locate the lawnmower solenoid.
  3. Step 3: Find the relevant terminals.
  4. Step 4: Clean the carbon and rust deposits from the terminal.
  5. Step 5: Jump the solenoid.


What causes a starter not to engage?



This fault is caused by either low battery power or loosen connections in the battery terminals or the terminals at the starter solenoid. Low battery power may be the leading cause of the issue. Jumpstarting the battery will ensure that the starter motor receives sufficient power to engage the flywheel.

Can you flood a lawn mower?

Flooding a lawnmower is easy to do. Turning the machine over to clean the bottom of it or remove the blades while it contains gasoline is enough to do it. Priming it too many times by pushing the primer bulb can also cause flooding.

How do you jumpstart a lawnmower?

Quote from the video:
Quote from Youtube video: First connect one end of the red jumper cable to the positive terminal on the mower battery connect the other end of the red cable to the vehicle's positive battery terminal.

Why is it so hard to start my lawn mower?



The fuel filter might be clogged. A clogged fuel filter is most commonly caused by leaving old fuel in the lawn mower. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the fuel filter and make the engine hard to start.

How do I know if my lawn mower spark plug is bad?

The more worn or dirty spark plugs are, the greater the tug on the rewind and more effort is required to produce an adequate spark. If you haven’t turned on your engine recently, your mower won’t start and/or you have to tug repeatedly on the rewind to start the engine, a damaged spark plug may be the culprit.

Will a bad spark plug cause a lawn mower not to start?

A dirty or fouled spark plug can cause your lawn mower to not start. It can also work itself loose, causing issues. If the spark plug appears to be seated correctly but the engine doesn’t start, a new one may be in order. For a few dollars, this easy fix can get your small engine working again.

Why does it take so many pulls to start my lawnmower?

Your lawn mower takes so many pulls to start because the fuel filter is filled with debris, the spark plugs aren’t working, the battery is damaged, or there’s not enough gas in the tank. A damaged engine can make the mower take more pulls to start because it won’t combust the oxygen and fuel.