Although it is fine to secure your light / fixture box to your chimney, it is not OK to put a 120vac power cord loose-lay on your roof in order to avoid risk of leaks. Power must be properly protected and secured.

Why are overhead cables hang loosely?

During transmission of electricity, heat is being dissipated. The heat generated by cables is being minimized via high voltage transmission. So, the cables are loose so that even if contraction should occur, there won’t be much tension which would lead to the damage of the cables.

How do you stop wires from getting loose?





A cable protector is one of the best ways to prevent unnecessary accidents in your home. For office cable management, a protector can keep your desk neat and tidy to reduce the risk of tripping and the like.

Do cables have to be clipped in loft?

I have just had some wiring done at home. Does the 17th edition require that cables run in loft spaces have to be clipped to joists or are loose runs ok?



See Also:

Technical discussion forums
· Wiring and the regulations
· Other and general engineering discussions
Archived categories


How do you know if your power cord is damaged?

Test for a potential short circuit by touching each prong on the AC side of the power cord. If the multimeter beeps, your power cord is bad and must be replaced immediately. If your power cord is shorted, do not attempt to replug the cord into the AC outlet.

Where will a power cord most often fail?





Installation showing direct buried cables and ducts. Cable accessories are often the most prone to failure of any part of the cable system. Accessories include terminations and joints, also called splices. Terminations are required to connect the conductor of the cable to a bus or other cable conductor.

Can a power cord go bad?

Extension cords and power strips: While extension cords and power strips don’t come with an expiration date per sae, they do have a limited lifetime use. These items are only designed to handle so much juice over the years and will eventually short out or lose effectiveness.

How do I know if my power supply is failing?

11 Signs of Power Supply Failure

  1. Computer turns on for some time then it suddenly turns off.
  2. Random black & blue screen crashes.
  3. Random Computer Crashes and Restarts.
  4. Display Issues.
  5. Freezing.
  6. Smoke/Burning Smell.
  7. Strange noises from the PC case.

How can you tell if an electrical outlet is bad?

Watch out for these signs that your outlet is due for a replacement.

  1. Outlet Replacement Sign 1: The Outlet Is Not Working. …
  2. Outlet Replacement Sign 2: Burn Marks or Melting. …
  3. Outlet Replacement Sign 3: Cracks and Chips. …
  4. Outlet Replacement Sign 4: Plugs Fall Out Easily. …
  5. Outlet Replacement Sign 5: Outlet Feels Hot to the Touch.

How do I fix my AC power cord?



Quote from the video:
Quote from Youtube video: One connect the wire connector then thread the screw to secure the grounding wire. Secure the wires in the twist. Retainer. Then position the strain relief in the notch in the service.

Can you replace AC power cord?

A damaged power cord doesn’t have to mean the end of life for a tool or appliance. Power cords are usually replaceable with simple tools and minimal expense. Here’s how to replace an AC power cord. If you can open up the device, do this.

How do you fix a broken cable?

Quote from the video:
Quote from Youtube video: Heat it with a heat gun or blow-dryer. And it will shrink to fit over the wire causing it to immobilize.

Can you splice an AC power cord?



Technically, you’re not supposed to splice extension cords. Even if you solder the wires, wrap each wire with electrical tape and encase the whole splice in heat shrinkable tubing, it still won’t have the abrasion resistance of a new cord. Plus, it’s not permissible under the National Electrical Code.

How do you splice an outdoor electrical cord?

Quote from the video:
Quote from Youtube video: Select one on is the smallest diameter. Possible that will still slide easily along the cord. Don't forget to take into consideration whether the heat shrink will fit over the splice section of wire.

How do I extend my mains cable?

Quote from the video:
Quote from Youtube video: It lightly into the crimping. Tool like so just gonna make sure that you click you're crimping down on the piece of metal that is inside here.