When recessing your hot tub into a deck, leave about 16-18” rise above the deck to allow for the cover to fit over the hot tub when not in use. Keeping your hot tub covered when not in use will save energy, prolong the life on the spa and avoid unnecessary hot tub maintenance.

How do you lift a hot tub on a deck?

Youtube quote:We have the slider. Under we have the red bar in place we're going to go up and pull some tension on it now and start the.

How do you build a raised platform for a hot tub?





The easiest way to construct a hot tub platform is to pound stakes at the corners of an 8 by 8 foot square. Make a smaller square of 9 stakes in the middle. Replace each stake with hole that’s 1 foot deep, and fill the holes with a few inches of sand. Place a footing on top and set a short wooden post in each footing.

How level does a hot tub need to be?

There should be a maximum of ½” (1.27cm) slope in an 8′ (2.44m) run. Do not use shims to level the spa, this could create tension on the spa shell which might result in damaging your spa. Because your spa pad must provide continuous support for the entire base of the spa, you should never level it with shims.

Can you put a hot tub on an elevated deck?

What about an elevated deck? Yes and yes. Installing a hot tub on your deck will help you get the most out of your investment. The closer the hot tub is to your house, the more likely you are to use it.

Can you put a hot tub on a tall deck?

A hot tub on a deck is entirely possible, and it is possible your deck is already equipped to handle one. A deck designed to hold at least 100 pounds per square foot will support nearly any type of hot tub.

What happens if a hot tub is not level?





Over time a spa being unlevel can cause stress to the acrylic and cabinet. As was said, a 1/2 inch total or 1/2 inch in 18 inches is a big difference. If something happens down the road to the shell or cabinet, and it is found that the tub was not level, they may not honor the warranty.

Can a hot tub be leveled?

Use plastic shims to level a hot tub if your hot tub rests on a slope of an inch or less, you can use the plastic shims to perfectly level the hot tub.. Using new concrete pad well, using a concrete pad also works as a good option for leveling the hot tub on uneven concrete. Your hot tub needs a solid,.

What is the best base to put a hot tub on?

A concrete surface is an excellent base for your hot tub as this material is extremely sturdy and long-lasting. If you have an existing patio made of concrete bricks, make sure it’s in good condition and is level (not angled for drainage). A customized poured concrete pad is an even better choice.

Can I put a hot tub on pavers?

A hot tub can be placed on pavers, but ensure that they can bear the weight of the hot tub, including water and persons. Ensure that the floor is level and solid. Most pavers are laid at an angle to improve rainwater removal. Such a slope is not suited for a hot tub.

Should I put a mat under my hot tub?



Although, if you want to use gravel for an easy foundation option, you’ll need an insulated ground mat to help with insulation and minimise heat loss through the spa base. This item will also add protection under the hot tub base to prevent any damage caused by sharp stones.

Can I put hot tub on gravel?

The construction gravel should be topped with another layer of smaller sized pea gravel until it is perfectly even with the edges of the excavated area. So yes, a hot tub can sit on gravel! To find out more about hot tub installation requirements, download a hot tub buyer’s guide.

Does a hot tub have to be on concrete?

Outdoor hot tub placement, such as decks, concrete or brick patios, is common. However, the hot tub can be placed on any solid, uniform, level surface. Do not place your hot tub on grass or bare ground.

Can you put hot tub on grass?



Can a hot tub go on grass? A hot tub CANNOT sit directly on grass or earth. A hot tub holds too much weight to sit on grass. It will inevitably sink, the environment beneath the hot tub will be wet and untidy and it could lead to rot if you have a wooden framed spa.

Does a hot tub need a concrete base?

Hot tubs are heavy even without having water in them. A large hot tub full of water can weigh upwards of 2 tonnes, so a suitable level base is vital. The most common base is a concrete foundation. Think about the size of the pad also.

How heavy is a hot tub?

How much does a hot tub weigh? There is no single standard hot tub weight. In general, a small two- or three-person hot tub generally weighs around 500 pounds empty and 3,000 pounds when filled with water. A six-person model typically weighs approximately 1,000 pounds empty or 6,000 pounds full.

What should I put down under my hot tub?

If you’re having a base installed especially for your Hot Tub we would recommend a patio, decking area or poured concrete base. Whatever you choose make sure whoever installs it for you ensures the base is level and large enough for your Hot Tub and steps.