How do I remove a kitchen sink without a lock nut?

Usually there are 4 plastic arms that hold the retainer in the middle of the plastic cone. Use a cutting drill bit on your drill to get in there and cut the plastic away. Once you cut away these pieces, the drain will come out, just pull up on it. you’ll then need to go to a hardware store and get a complete drain.

How do you remove a sink strainer screw?





If you see screws holding your strainer in place, remove them with the screwdriver before loosening the locknut by hand. For a locknut with no screws, you’ll need to use a wrench to loosen it by turning it counterclockwise. Then, you should be able to wiggle the strainer loose and push it out of the sink.

How do you remove a locknut from a sink?

How to Remove a Stuck Locknut From a Sink Drain

  1. Attach large, slip-joint pliers onto the sides of the locknut. …
  2. Add heat while using the slip-joint pliers. …
  3. Grip the tabs on the locknut and twist them off, using a pair of pliers.

How do you remove a kitchen sink strainer?

Quote from the video:
Quote from Youtube video: You can take the mounting cup off the bottom. And also the old rubber seal. And then once that's removed. Then the strainer body itself will be easy to just pop up through the sink.

How do you remove a plastic sink strainer?

Quote from the video:
Quote from Youtube video: Place down a towel and a pail under the p-trap to catch any water this setup has two trap adapters. And one union p-trap to loosen off to be able to remove.

How do you remove a stubborn sink drain?





Tap the bottom of the sink drain flange from beneath the sink with the side of the pliers if the flange is stuck to the edge of the sink opening. This should loosen the grip on the flange and allow you to lift it from the sink.

How do you remove a push plug from a sink?

Push and Pull

  1. With the stopper in the open position, unscrew the knob from the stopper base.
  2. Push the stopper closed to reveal the center post.
  3. Use pliers or a flat-head screwdriver in the center to loosen the slotted screw inside the center post in a counterclockwise direction.
  4. Lift the stopper from the drain.


What tools do you need to remove kitchen sink?

Tools

  • Putty Knife.
  • Pipe Wrench.
  • Socket Wrench.
  • Utility Knife.
  • Safety Glasses.
  • Drainpipes & Fittings.
  • Tape Measure.
  • Adjustable Wrenches.

How do you remove a pivot rod from a sink?



How to Replace a Pivot Rod Under a Sink

  1. Look beneath the sink and behind the drain to find the pivot rod. …
  2. Unscrew the retaining nut that holds the pivot rod inside the drain. …
  3. Pull the pivot rod out of the drain. …
  4. Slide the retaining nut and washer off the original pivot rod.

How do you remove a Click Clack sink plug?

Quote from the video:
Quote from Youtube video: Grip it and turn that anti-clockwise until it comes loose. And then when it's loose. It will just turn. Until it comes out and so there's a thread at the bottom that fits into the fitting.

What is a pivot rod?

A sink pivot rod, also known as the ball or horizontal rod, is that part of a pop-up assembly that transfers vertical motion to the stopper when you move the lift rod up or down. Fixing a broken pivot rod isn’t that hard, but you do have to work in tight quarters.

What does plumbers putty look like?



Quote from the video:
Quote from Youtube video: Hi I'm Vance and welcome to repair and replace plumbers putty is a clay-like substance used to make watertight seals on faucets and drains. It's not an adhesive.

Are you supposed to let plumbers putty dry?

You can start using the sink drain or faucet immediately after installing plumbers putty. There is no drying time because it doesn’t dry. It just seals the gaps and the sink, drain, or faucet which can be used immediately after application of the plumbers putty.

Do you need plumbers putty for kitchen sink?

If you need to stop or prevent leaks around your faucet, sink or tub drains − plumber’s putty is the product you need. Plumber’s putty is a sealing staple for professionals, homeowners and DIY-ers alike.