Why is my Trane furnace not blowing hot air?

If it seems like your Trane furnace just isn’t heating your home as effectively as you want, then the culprit might be a lack of airflow, making the first step in repairing a Trane furnace checking your filters for blockages. A dirty filter can reduce airflow and prevent the correct functioning of your furnace.

Why is my heat not heating up?





Dirty filters are the most common cause of furnace problems. Dust and dirt restrict airflow—and if the filter gets too clogged, the heat exchanger will overheat and shut off too quickly, and your house won’t warm up. If the blower is running but no heat is coming out, replace the filter.

How do you troubleshoot a Trane thermostat?

Troubleshooting tips



To unlock a Trane thermostat, press the plus (“+”) and minus (“-”) keys at the same time for three to four seconds, then try adjusting the temperature again. If this doesn’t work, try resetting your thermostat with the reset button, changing the batteries, or cleaning off any dust and dirt inside.

How do you turn on the heat on a Trane?

Youtube quote:And into heating you go back to the system mode button at the bottom of the screen. From there you will select heating. This one will highlight and then you press apply.

Why is my furnace blowing cold air instead of heat?

A clogged filter is one of the leading reasons for a heater blowing cold air. But even if you swap the air filter with a brand new one, dirt and debris can still be found within the unit. This could eventually lead to overheating. If your furnace looks pretty dirty, call an HVAC provider for a professional clean.

Why did my heater stop blowing hot air?





If your heat pump is not blowing warm air, the refrigerant may be the problem. The unit could be running low and need additional refrigerant added. Needless to say, this isn’t something you can do on your own. A refrigerant leak can cause this problem.

Can Hear furnace but no heat?

When you turn the furnace on but no heat comes out, there may be an obstruction. Dirty air filters restrict airflow, which can make it feel like not much heated air is coming out of your vents. Check the furnace filter and replace it if its surface is covered with contaminants.

Where is the furnace reset button?

blower compartment

Locate the reset button on the furnace and press it to reset the furnace. It is usually located inside the blower compartment on the side of the blower motor. Be cautious as the housing may be hot. If the button is popped up, press it down.

Is there a reset button on a Trane furnace?



To access it, you’ll need to remove the front panel of the furnace. You may find that many models have limit switches where the reset button is located. The button is often located on top of the switch and will need to be pressed to initiate the reset.

How long does it take for furnace to reset?

Leave the breaker(s) off for at least 10 minutes while the system is off and “rebooting.” After 10 minutes have elapsed, go back to the breaker box and flip the HVAC breaker(s) back on.

What would cause a furnace to not kick on?

Ensure your furnace filters are clean: Your furnace won’t start up if it does not get enough airflow. A dirty air filter can prevent airflow and prevent your furnace from starting up. Check your pilot light: If you have a gas furnace and gas supply is stopped your pilot light will go out.

How do I reset my heating unit?



Youtube quote:Or turn the power off to the furnace system count to about 30 and turn it back on. So the next step is to turn the power. Off count to about 30 and turn the power back.