For units with non-screwing bump knobs, grasp the tap button of the bump knob in one hand and the shaft of the weed eater in the other hand, for leverage. Pull straight out to remove the bump knob from the hub. You may have to pull hard to remove the knob.
How do you get a weed eater cap off?
Quote from the video:
Quote from Youtube video: See that then what you do is grab these grab some pliers that are skinny enough to get in there. And get around that axle that you can see squeeze it tightly and then you can just twist the cap.
How do you take the head off a Ryobi weed eater?
Using your left hand, grasp the shaft housing firmly. Then bring up your right hand and wiggle the cutting head upward. Do this in a gentle manner. Just continue doing this until the head slips off the nut (specifically the hex nut which the head nestles on).
How do you put a bump on a weed eater head?
Quote from the video:
Quote from Youtube video: So just put your finger over the top pop the cover back on the way it was before. So just slop them into place. Once. It's ready pop that through and you can see that's now ready to go.
How do you remove a Ryobi bump knob?
Grasp the bump knob on the center of the cutting head and turn it counterclockwise to loosen it. Pull the bump knob straight off the cutting head.
