How do you fix the wood behind the strike plate?
Quote from the video:
Quote from Youtube video: You can wood filler over the cracks sand it after it dries and it'll be like new so we've got our block all in there nice and tight.
How do you fill a strike plate hole?
Quote from the video:
Quote from Youtube video: Stuff Durham's water putty I put some of this water putty onto a plate and I mix it with a screwdriver. Now I'm using the same screwdriver.
How do you mortise a strike plate on a door?
Quote from the video:
Quote from Youtube video: And when lining up the strike plate make sure that it sticks out past this point where the metal starts to curve. Down so i'll align it on the door jamb to stick out just past that point.
How do you put a strike plate on a metal door frame?
Quote from the video:
Quote from Youtube video: Things get better hacksaw. File theories still the same you replace the drill with the hacksaw. Make your marks. And then file them out to the lines.
What is a Dutchman patch?
Woodworking. In construction and woodworking, a dutchman can refer to an inset wood patch used to repair wood. Typically a square inset is cut into the damaged area and a new piece of wood is glued into the inset.
How do you fix a door jamb strike plate?
Quote from the video:
Quote from Youtube video: So here I'm simply marking the new location where I want to install my strike plate. And then chiseling it out. As you can see the new holes I need to drill are very close to the original.
What do you use to fill a hole in a door frame?
A wide variety of wood fillers, putties, patches and epoxies can do the job; in general, use an epoxy for more significant repairs, and use a filler or spackle that accepts a stain or comes in the color of your door frame for surface fixes.
How do you cover a hole in a door frame?
Quote from the video:
Quote from Youtube video: I like to use Durham's rock hard it's got the strong guy on the front.
What is a box strike plate?
A box strike gives the lock a far stronger hold on the door, and the 2-inch screws anchor it to the door frame.
What does lip on strike plate do?
A Large Lip strike plate reinforces locks, covers small holes and deters tampering or kick-ins. Includes metal and wood screws.
Are strike plates necessary?
Strike Plate
This is the plate the latch-tongue, or deadbolt-tongue will connect with. It should sit flush with the door jamb. Any passage or privacy set needs to have a strike plate for the door to latch. Additionally, deadbolts need a strike plate to properly lock.
How do you install a strike plate on a box?
Quote from the video:
Quote from Youtube video: So knock out these pilot holes with the eighth of an inch drill. Bit grab that security strike plate again. Put it back in place and then I'm just going to hand tighten. These.
How do you reinforce a door jamb?
The best way to reinforce your frame is by adding a layer of steel to prevent them from splitting. This makes your door kick proof. Installation entails placing high-gauge steel over the door jamb and securing it with long screws. The screws should penetrate through to the wall studs on all sides of the doorway.
How do strike plates move?
You will need to carve out the jamb a little to recess the plate in the new location, simply run your screws snug to hold it in place, then run your razor knife around the edge that needs recessing, remove the plate, score your line to the necessary depth, then flat cut the debris out of the way.
How do you make a strike plate hole bigger?
After removing the strike plate from the door frame, use a metal file to enlarge the strike plate hole. A half-round file will match the curvature of the latch hole, making it the best choice for widening the strike plate hole.
