It’s generically called a “grommet” or “bushing” — do not know a brand name. To remove it you (from the bottom) squeeze the two halves together with a pair of pliers, then push it out.
How do you remove a lamp cord grip?
Quote from the video:
Quote from Youtube video: And squeeze and pull the top of the lamp out of its holder be careful not to squeeze this piece so hard that you put it out of round. It.
How do you use cable clips?
Quote from the video:
Quote from Youtube video: The cable along the desired path insert the clip over the cable and hammer it into your installation surface for all your insulation needs choose show me cables.
How do you unwire a lamp?
How to Rewire a Lamp
- Remove Old Socket. Before starting, make sure lamp is not plugged in. …
- Cut Old Wires. Pull the socket up and use the wire cutter to cut/disconnect the old wires. …
- Split the Wires and Knot Cords. …
- Connect Wires. …
- Snap Sleeve On and Test.
How do you remove a power cord clip?
You need to squeeze, preferably with a needle-nose pliers, in what I would call a top-to-bottom position considering the orientation of how it is installed. If you squeeze just right it will come out no problem and will not damage the cord. Rest assured, it CAN be done with a regular pliers if you’re careful.
How do you remove wire clips?
Quote from the video:
Quote from Youtube video: Well it's actually pretty simple you grab a hold of this on one end and you grab the wire on the other. And you simply twist. While you pull them apart.
What is cable clip?
What is it? A cable clip is a device that manages wires and cables and secures them to a fixed point on a surface, like a wall, ceiling or floor. A wide range of cable clips is available to control cables of all sizes and shapes, in almost any number, in both home and industrial applications.
How do you hammer wire clips?
Quote from the video:
Quote from Youtube video: And then you just hammer your cable clip into the pin. So when you're hammering down the wall instead of trying to hammer this into your render or your pebble – you just hammer it into the pin plug.
How do you hammer cable clips?
Quote from the video:
Quote from Youtube video: And you line the nail up with the dowel that you just banged into the wall and just simply bang the clip in place. And that's it solid. See that is much easier.
How do you remove a wire from a connector?
Quote from the video:
Quote from Youtube video: So all we're going to do is take a pin removal tool that comes with this kit when you buy it. And we just slide that down over the wire. And the pin.
How do you remove a NM cable connector?
You can remove them from the knockout by applying pressure to the inside lock tabs with a screwdriver, However, it’s a locked wedge fit around the wire and generally requires cutting the wire. If you’re careful you could probably use a tiny tim type hacksaw and cut the nylon connector.
