You want 3 1AWG Al XHHW-2s here with an 8AWG ground.
What size wire do I need for a 100 amp sub panel 100 feet away?
If you check the wire size chart (you have the link in the introduction), the #0 AWG wire (also known as 1/0 AWG wire) has 150 ampacity. That means that #0 AWG wire is the perfect size wire for 100 amp service 100 feet away.
What size wire do I need to feed a 100 amp subpanel?
The cable must have a wire gauge sufficient to the amperage of the subpanel—a 100-amp subpanel requires #4 copper wires or, more commonly, #2 aluminum wires, for example. (Aluminum is often used for feeder cables because the cost is typically much lower than that of copper wires.)
What size wire do I need for 100A service?
For 100 AMP service, you’ll need a #4 AWG copper wire or #2 AWG aluminum or copper-clad wire. Make sure to limit your voltage drop to 3% regardless of distance.
What wire gauge do I need for a 100 amp subpanel at the end of a 60 wire run?
You need a 3-3-3-5 copper SER cable to carry 100 amps (that’s three #3 gauge for the two hot wires and the neutral and a #5 gauge for the ground). If you want to use aluminum, you need at least #2 gauge or perhaps #1.
What size wire do I need to run 100 amp Service 150 feet?
Quote from the video:
Quote from Youtube video: What size wire do i need to run 100 amp service 150. Feet what is the right wire size for 100 amp service 150 feet distance you should get two over zero awg copper wire or four over zero awg aluminum
What size copper wire is rated for 100 amps?
Wire Size and Amp Ratings
| Wire Size | 75°C (167°F) | |
|---|---|---|
| AWG | (mm²) | Copper |
| 6 | (13.3) | 65 |
| 4 | (21.2) | 85 |
| 3 | (26.7) | 100 |
What size wire do I need for a 100 amp underground 300 ft run?
for 300 feet for 100 amp rated service I would use Aluminum direct burial 1/0-1/0-1/0-1/0, the forth can be as low as #4 for the ground (but also in conduit, even if in conduit must still be rated underground wire and required by code also) Also note the size wire the breaker can handle, cannot cut strands to make fit,
How do you wire a 100 amp subpanel?
Quote from the video:
Quote from Youtube video: You could feed that panel from a 60 amp breaker inside of wherever. Your main panel is and that would still be fine you're just using that 100 amp breaker as a disconnect.
How far can subpanel be from main panel?
The right feet would be between 4.5 to 5 feet.
The cable running from your main panel to the subpanel depends on the amperage rating. For instance, for a 30A panel, use a 10 AWG, three-wire conductor.
How many amps can a 100 amp panel handle?
For example, a 100-amp service panel could have circuit breakers that add up to more than 200 amps.
Can I run a 100 amp sub panel off 200 amp main?
Can you add a 100 amp breaker to your main panel? Yes you have 12 slots the double pole breaker will only take 2 slots.
Can I run a 200 amp sub panel off 200 amp main?
Is feeding a 200A sub from a 200A main legit? Yes, and you don’t even need another 200A breaker. The 200A breaker alread present in the panel will suffice, and so you can use a subfeed lug kit as DrSparks advises.
