The only way to make this a smooth cut is with a circular saw, either hand held or a table saw. You need a very sharp high tooth count carbide toothed blade. to achieve a smooth cut will require some planning.
What is the best way to cut laminated chipboard?
Use a circular saw and make sure the blade cuts up into the laminate before the substrate. Usually this means you cut the laminate from the underside, its impossible to get a clean cut on a double sided piece of laminated sheet. I cut worktops with a circular saw and the cuts are perfect.
How do you cut laminated chipboard without chipping?
To cut melamine or laminate boards without chipping, your saw must be equipped with a double-sided laminate / melamine blade. These blades are specially designed for cutting and at the same time minimize chipping. Before making your cuts, get your table sawed as best you can.
How do you cut chipboard cleanly?
Always use a sharp craft blade. A dull blade is harder to cut the chipboard and increases the risk of cutting yourself because more pressure has to be applied. Keep hands to the side of the craft blade when cutting. Always cut away from your body.
How do you cut laminated chipboard by hand?
Quote from the video:
Quote from Youtube video: Always start by pulling toward. You so I'm going to start on the line. And just drag it a little bit.
How do you cut a laminate board?
Here are the steps to follow and the pro tips you need to make splinter-free cuts:
- Step 1: Measure & Score. Measure and draw out your cut line, and then score the laminate on both sides of the cut line using a utility knife. …
- Step 2: Adjust Your Circular Saw & Make a Scoring Cut. …
- Step 3: Make the Final Cut.
How do you cut laminated MDF without chipping?
Just cut upside down with a circular saw and straight edge clamped to the chipboard. Make sure you’ve got a sharp fine toothed blade and you pass through slowly. No need to mess about with a router.
How do you cut laminate sheet with utility knife?
Turn the laminate one-quarter turn and align the square along the next cut line. Draw the knife across the surface, applying firm pressure, two or three times. Shift the score line to the table edge and break the laminate again. Repeat for any additional cuts.
