Using Bleach in Your AC Drain Simply open up the drain line clean out or T on your inside unit and pour a 50/50 warm water and bleach mixture OR warm water and vinegar solution through the line. Be sure to use a minimum of 2 cups once or twice per year.

Can I pour bleach in my AC drain?

Luckily, you can clean your AC drain line with bleach or vinegar (or even peroxide) to dissolve the clog and remove any bacterial buildup.

How much bleach do you put in an AC drain line?





While holding the funnel steady, carefully pour two quarts of laundry bleach into the funnel and allow it to find its way into the drain line. If the bleach begins gurgling or doesn’t drain quickly, then pause and wait for a few seconds.

What can I pour down a clogged AC drain?

By pouring a ΒΌ cup of vinegar into your AC’s drain line, you will kill any mold, algae, mildew, and other forms of bacteria or fungi, preventing it from forming a buildup and causing a clog. Repeat this monthly for the best results.

How do I unblock my AC drainage hole?

How to Unclog Your AC Condensate Drain Line

  1. Turn off your air conditioner. …
  2. Remove the cap from the pipe. …
  3. Check to see if there is any debris stuck in the drain. …
  4. Remove any visible debris and retest for proper drainage. …
  5. Pour in Vinegar. …
  6. Replace the drain cap. …
  7. Remove the drain cap.

Can you put bleach in condensate pump?

If you have a condensate pump, the bleach will fill up the water reservoir and turn on the pump cleaning out the vinyl exit tubing. If you do not have a clean out “T” on your system, it is very easy to add one.

Where do you put bleach in a Carrier air conditioner?





Just pour a cup of bleach in the drain line’s access opening near the indoor air conditioning unit. This will kill any algae, mold or mildew that has formed in the pipe. If the condensate drain line is clogged, you will need to use a wet-dry vacuum or a special pump to unclog the line.

How often should you pour bleach down your AC drain?

Using Bleach in Your AC Drain Be sure to use a minimum of 2 cups once or twice per year. Be advised, however, some newer units no longer recommend bleach or vinegar due to oxidation/degradation concerns.

Is bleach or vinegar better for AC drain line?

We recommend using vinegar instead of a bleach solution because bleach can be harmful to your AC system if your drain line has copper tubing. Using vinegar will not damage your system. Spilling bleach can also ruin carpet or clothing, whereas vinegar will just leave a strong odor.

How do I unclog my AC drain without a shop vac?

If you have a very stubborn clog that doesn’t come out with a shop vac and water, then you can try using a drain snake. Push the drain snake down into the drain line access near the air handler. Make sure the that the drain snake does not go towards your air handler or you could potentially damage the evaporator coil.

How do I unclog my AC drain line in my attic?



Use the suction hose of a wet/dry vac to suck the clog out. Remove the cap from the condensate drain line. Fix the hose attachment to the wet/dry vac’s hose, and position it into or flush with the end of the drain line. Then, use duct tape to seal the gap between the hose and the drain line.

How do you suck out an AC drain?

Directions

  1. Turn off your air conditioner. …
  2. Locate the drain line. …
  3. Use a wet/dry vacuum to remove the clog. …
  4. Use a garden hose to clear the drain line. …
  5. IMPORTANT: Make sure the water flows down the drain line, not back into your AC system. …
  6. Clean your AC drain line. …
  7. Replace the cap and turn your AC system back on.

How do you unclog an AC condensate pump?



Cleaning a Condensate Pump in 8 Steps

  1. Inspect the condensate pump for water. …
  2. Turn the power off at the source. …
  3. Disconnect the PVC tubing connected to the reservoir.
  4. Remove the condensate pump and place it in a suitable work area. …
  5. Rinse the reservoir. …
  6. Remove any clogs. …
  7. Reconnect the drain lines.

Is it OK to put bleach down the drain?

Bleach is a powerful, toxic substance that should be used carefully and properly, and pouring it down a drain is not a proper use. Bleach can react with other substances in your pipes, potentially release fumes, and further plug up the system.

How long pour bleach down drain?

Carefully pour some bleach into a cup and dump it down your bathtub or shower drain. Let it sit for about 15 minutes and then flush the drain with hot water. Don’t leave the bleach much longer than that, or it may corrode your pipes.

Does bleach damage PVC pipes?

Skip the bleach, not because it will harm your PVC, but because you are wasting your time. On a side note, there are some chemicals that absolutely must be avoided when cleaning toilet bowls or you risk damaging your pipes. Those include acetone or nail polish remover, or even PVC pipe cleaner.

Can you pour bleach down a smelly drain?



The simple solution to this issue is to fill the sink with hot water and bleach, then drain the water through the pipes. This will help dislodge stuck food and other debris, allowing them to wash away.

Does bleach dissolve plastic?

Yes, it is corrosive to plastic. It does not eat up the plastic in one go (we are assuming you are using the diluted bleach or bleach water as the cleaning agent), but the damage it would create is definite.