Dirty or faulty flame sensor If your furnace turns off after a few minutes, there is a good chance it is caused by a faulty or dirty flame sensor. This vital component is designed to keep an eye on the gas burner. When it cannot sense that burner, the furnace runs then shuts off and starts again.
Why does my furnace stop and then start again?
This behavior is caused by something cutting short each furnace cycle since your furnace is being forced into a short cycle to keep your home the temperature set on your thermostat. A furnace that is sized properly for your home should start and stop 3-8 times in an hour.
How do you fix a furnace that keeps shutting off?
Quote from Youtube video: And now it's calling for Heat. And then it turns off so the problem is a dirty flame sensor nine. Times out of ten so I'll show you the steps on how to keep that clean once a season in this furnace we
How do I stop my furnace from short cycling?
Quote from the video:
Quote from Youtube video: So to fix this issue shut off your thermostat. And open up the furnace. And then replace the batteries on the thermostat.
What does it mean when your furnace won’t stay on?
Probably the most common issue when dealing with a furnace that will not stay lit or ignite consistently is a dirty flame sensor. The flame sensor acts as a communication vehicle with the circuit board and tells it when a flame is lit inside the furnace.
Why does my furnace run for 5 minutes then shuts off?
If your furnace turns off after a few minutes, there is a good chance it is caused by a faulty or dirty flame sensor. This vital component is designed to keep an eye on the gas burner. When it cannot sense that burner, the furnace runs then shuts off and starts again. This could be a relatively easy fix.
How do you clean the ignition sensor on a furnace?
Quote from the video:
Quote from Youtube video: So if you have a situation like this what you have 90% of the time is just a dirty flame sensor. So we'll go through the steps on how to clean it. So the right side of the furnace.
How do I know if my furnace flame sensor is bad?
Signs of a bad flame sensor
- Furnace burners turn on but go out after a few seconds.
- Soot and other debris is covering the end of the sensor (cleaning the flame sensor may fix this issue rather than a flame sensor replacement)
- Tip of flame sensor is black.
- Porcelain/sensor casing is cracked.
How do I know if my flame sensor is dirty?
6 Signs of a Malfunctioning Gas Furnace Flame Sensor
- Yellow Burner Flames. Open up or glance through the peephole of your gas furnace to see the color of the flames firing up in the burner. …
- Rusted Flue Lines. …
- High Utility Bills. …
- Water Leaks. …
- Old Age. …
- Constant Thermostat Adjustments.
