Can GFCI and lights on same circuit?
Electrically there is no problem with powering the light with the hot and neutral feed to the GFCI receptacle. You could use pigtails to the receptacle line (and not use the load connection) and to the light switch so the lights would’t go out if the GFCI receptacle tripped.
Can you run power from a GFCI to a light switch?
In general, yes. GFCI outlets have LINE and LOAD terminals. You can connect several more outlets on the LOAD terminals, and they will also be protected from ground faults. You can also add a switch, though bear in mind that highly inductive loads (like a large motor) can cause nuisance tripping of the GFCI.
Can you wire a switch from a GFCI outlet?
Is the proper way to wire this: Place the switch in the hot wire going to the “line” side of the GFCI outlet. Run the neutral wire uninterrupted to the “line” side of the GFCI outlet. Connect ground wires as usual, switch and outlet.
Can you wire a light and switch from an outlet?
Run a cable to the light fixture and another cable to the outlet from which you’re drawing power. Turn off the power to the outlet, and before making connections, test the leads with a voltage tester to make sure they’re dead. At the outlet, you connect the cable to the load terminals.
How do you hook up a light switch to a GFCI?
Quote from the video:
Quote from Youtube video: And then the same black line continues on in parallel. And goes over to the GFI switch. This is the way you want to do it when you have a light switch next to the GFI.
Will LED lights trip a GFCI?
Electrical Problem with an LED Light Tripping a GFCI Outlet
The GFCI Outlet must be wired from the wiring of the same circuit, therefore the wiring must be contiguous, and not connected to other circuit wires because this could cause the GFI Outlet to trip, but there is more to this problem as described below.
Should bathroom lights be on GFCI?
As mentioned above, GFCI protection is required for any electrical outlets or switches that are in the area where you could get wet while using your bathroom.
Does light above shower need to be GFCI protected?
Master electrician Sean Kenney responds: The short answer is yes. Although the NEC does not require either the switch or the light fixture to be GFCI-protected, most lighting fixtures designed for use in a shower stall require GFCI protection to meet UL requirements.
Do bathroom lights need to be on their own circuit?
The bathroom electrical code now stipulates that the bathroom must have dedicated circuits that aren’t shared with outlets or lights in any other room. You must provide at least two of these circuits. One is a 20-amp circuit that powers the outlets, and the other is a 15-amp circuit for the lights.
Can two bathrooms share a GFCI circuit?
It does not require a separate circuit for each bathroom. One circuit may supply multiple bathrooms as long as only bathroom receptacles are supplied. Lighting outlets or receptacle outlets in other rooms may not be supplied by this circuit.
Does a GFCI outlet need a dedicated circuit?
GFCI requirements are a separate issue – they do go along with dedicated circuits in the kitchen and bathrooms but in other areas they can be shared with non-protected receptacles.
