Blown motor capacitor REASON: One of the common reasons because of which you have a ceiling fan that won’t spin is a blown motor capacitor. The motor capacitor may simply burn out due to either overheating or age. If you have been using the fan for a long time, then the chances of this may increase.

What causes a ceiling fan to stop spinning?

If your ceiling fan stopped working or is not turning on, it could be because it isn’t receiving any electricity. This could be because the circuit breaker has tripped or is off. Check your panel to confirm this. If the circuit breaker works fine, it could be a problem with loose wiring and connections.

Why is my fan humming but not turning?





So, what causes the motor to hum? The first step in fixing a ceiling fan that hums but won’t turn is to check your circuit breaker as well as the switch that controls the fan. After that, try manually rotating the blades and if they don’t spin, then you know you have a problem with the ball bearings.

How do I know if my ceiling fan motor is bad?

Quote from the video:
Quote from Youtube video: And you have that loud humming sound a lot of times you'll just smell almost an electrical burning smell. That your motor out.

What to do if fan is not rotating?

Ceiling fan not spinning: Causes and solutions

  1. Check the switch. The first thing that you need to do is to make sure the ceiling fan is receiving power from the switch. …
  2. Check the circuit breaker. Another possible cause for ceiling fan not spinning could be a defective circuit breaker. …
  3. Other things to check.


Do ceiling fans have a reset button?





There are several ways to reset a ceiling fan remote, but here’s the most straightforward: With the power off, hold down the button until the light on the remote flashes. Then, press and hold it again for 15-30 seconds to resynchronize the remote with your fan.

How do you fix a stopped up ceiling fan?

Quote from the video:
Quote from Youtube video: Make sure all the screws around light shades are secure then tighten any loose bulbs. If it's still noisy turn off the power at the main panel. Then check the wire nut connections.

Can a capacitor cause ceiling fan hum?

Faulty capacitors



The final thing that can cause humming or buzzing noises in the ceiling fan is the capacitor. A capacitor is part of the electrical circuit that stores electrical charge. In a ceiling fan, it’s used to regulate speed, change direction, or for another use.

How do you fix a humming fan on a motor?

Quote from the video:
Quote from Youtube video: Your blades are out of balance which is causing this annoying little vibration inside the motor itself. You can use a sink. It for your blades.

Can a ceiling fan motor be repaired?



If the motor does turn out to actually be the problem, you can certainly replace it. Some motors simply plug in and out of the fan. If you’re not lucky enough to have one of those, you’ll have to wire the new motor into place, matching the colored wires.

How do you test a ceiling fan capacitor?

Quote from the video:
Quote from Youtube video: Some of them you'll discharge by bridging the leads from one side to the other of the capacitor.

How long do ceiling fans last?

10 years



Most ceiling fans are estimated to last for a maximum of 10 years, but the length of time your ceiling fan should last does depend on how much you use it.

How do you reprogram a ceiling fan?

Quote from the video:
Quote from Youtube video: You want to turn off the power on your switch. And they know you want to do is press those two buttons the up/down button for 10 seconds. You should hear the fan beep.

Where is the DIP switch on a ceiling fan?

Quote from the video:
Quote from Youtube video: So the remote dip switches can be found on the back of the remote under the back cover so you take the back cover off usually they're somewhere near the battery.

How do I adjust the speed of my ceiling fan?

Check the pull chain switch on the fan. A bad switch, or missing speed setting, will cause the fan to run slowly. Turn the fan off and allow it to stop moving. Pull the chain and turn the fan on the lowest setting, then listen to the fan motor as you pull the chain and move through the progressive speed settings.