The closet is a frequently remodeled area; the walls are brought down to create more space. But before you can bring down a closet wall, you’ll need to ensure that it’s not a load-bearing wall. Closet walls can be both load-bearing or non-bearing.

Is my closet a load-bearing wall?

Usually the walls on the eave side of the building are going to be load bearing. But if there is a second floor in this area, the closet walls could be supporting.

Is a closet header load-bearing?





Automatically, builders know that a two-by-four header means either an interior, non-load-bearing wall (one that doesn’t support the roof and a second story, if applicable) or an opening 3 feet wide or less. A regular header, on the other hand, must be used for load-bearing walls, whether interior or exterior.

How do you tell if it’s a load-bearing wall?

Step 1: Determine Whether a Wall Is Load-Bearing or Not

  1. Check an unfinished basement or attic to see which way the joists run.
  2. If the wall runs parallel to the joists, it’s probably not load-bearing.
  3. If it’s perpendicular, it most likely is a load-bearing wall.


Can you remove the wall between two closets?

Closets are great for out-of-sight storage, but they reduce your living space. Fortunately, at least one of the walls dividing the closet from the rest of the room is always non-loadbaring. A non-loadbearing wall can be removed without affecting the structural integrity of your house.

Do closets have studs?






Quote from Youtube video: Right in there hollow there's another stud. Right there and and you should measure between them generally they lay out walls every 16 inches.

How do you know if a partial wall is load-bearing?

Walls that run perpendicular to the joists are load-bearing walls. Walls that are parallel to the joists rarely are, but sometimes a bearing wall will be aligned directly under a single joist. If purlin bracing is attached to the top of a wall or is supported by a wall, it’s a load-bearing wall.

How much does it cost to remove a closet?

Closet remodel cost:

National average cost $358
Average cost range $299-$501
Low-end cost range $113-$271
High-end cost range $644-$1,275


How do you expand an existing closet?



6 Ways to Expand Your Closet Space

  1. Add A Set of Wire Shelving. Everyone has an area of their closet that’s more of a hidden space or unused area. …
  2. Second Story Shelves. Do-it-yourself shelves expand your closet space tremendously. …
  3. Double Your Rods. …
  4. Back of Door Storage. …
  5. Closet Organizing Ideas that Expand Your Closet Space.


How do I remove an existing closet?

Quote from the video:
Quote from Youtube video: Over the screws you may need to scrape out that paint. So you can actually get the screws undone. We'll remove the brackets. And then the next step will be the boards that are attached to the drywall.

How do you take down a closet wall?



Quote from the video:
Quote from Youtube video: So then I have just framing to deal with and then I can like sawzall the nails top. And bottom and then just slowly. Take this apart piece by piece.

How do you open a closet wall?

Wearing safety goggles, cut and remove drywall in small sections in order to peek into the wall to check for obstructions. Use a reciprocating saw to cut any of the framing out of the way. Reframe the opening, using 2-by-4 studs on each side of the new opening. Make sure the new 2-by-4’s are plumb and level.

How do you knock out a built in wardrobe?

Insert a crowbar behind the wardrobe and against the wall behind the wardrobe. The space may be tight, but the crowbar is slender enough that it can fit into small spaces. As you gently pull back toward yourself with the crowbar, you will release the fitted wardrobe from the wall bit by bit.

Are fitted wardrobes a good idea?

‘From a practical and aesthetical perspective, fitted wardrobes offer the most effective and efficient way to make use of the space within your bedroom. Before exploring wardrobe options it’s worth being clear about your requirements, budget, and desired style.

Can fitted wardrobes be moved?



Unlike a freestanding wardrobe, you can’t take a fitted wardrobe with you when you move house.

Can you put fitted wardrobes on carpet?

Putting fitted wardrobes over carpet is a no no as carpet will continue to move and stretch over time and will alter the fit of the wardrobe frames. Always fit carpet up to the wardrobes even if the carpet is already down, peel it back then re fit. It takes 5 minutes to do the job properly.

Do fitted wardrobes add value?

Whilst most people usually buy fitted bedroom furniture to give them more storage space and accommodate awkward nooks within a room, an added benefit is that it can add value to a property. If fitted to a high standard by a reputable firm, the added value can even surpass the total cost of the installation.

Do you carpet before or after fitted wardrobes?

Answer – It does not really matter, but we recommend you fit the wardrobe first and lay the carpet up to it. By doing it this way, not only would the floorboards be a better base for the wardrobe, but it will save a lot of time and money later if you were to change the carpet at a later date.