1 Answer
- Make a complaint in writing and mail it signed return receipt (to prove it was sent and received). …
- Take pictures. …
- Get 3 quotes of what it would cost to repair the floor; obviously not from the guy who damaged them.
- Be careful about what you do or do not pay the contractor.
How do you fix gouged wood floors?
Gouge: For a deeper scratch or small gouge, rub a matching colored wax filler stick or brown crayon on the spot until the nick is filled. Rub the spot with a soft cloth to remove any excess wax. Deep Gouge: For a deep gouge, fill the hole with matching colored wood putty.
What causes pitting in hardwood floors?
Causes of Hardwood Flooring Dents. Dents result from heavy items being dropped or dragged across the floor, which compresses the fibers in the wood and results in visible damage.
How do you fix pitted wood?
How to Repair Pitted Wood Floors
- Buff the pitted section with fine steel wool. …
- Apply mineral spirits to a clean sponge and use it to clean the damaged section of wood flooring. …
- Wipe the floor with a clean wet rag, then wipe dry.
- Choose a wood putty that matches your existing floor. …
- Wait for the filler to dry.
How do you fix gouges in engineered hardwood floors?
Use a smooth-edged flexible steel putty knife to apply the wax or putty filler to the hole in the floor. Put just enough filler on the knife end to fill the hole with only slight excess. Apply the filler to the hole moving at an angle that is diagonal to the length of run of the floor board or gouge or hole.
How do you repair deep scratches in laminate flooring?
The surface of laminate flooring cannot be sanded, so scratched or scraped laminate flooring has to be repaired with wax or putty. It may even need to be replaced. Pro Tip: Buy an extra box of laminate for replacing damaged planks that cannot be repaired.
How much does it cost to fix a scratched wood floor?
Scratches cost anywhere from $75 to $2,000 or $1 to $8 per square foot. For a single scratch, you might go with an inexpensive wood filler and stain. For extensive scratches, you’ll likely need to refinish the floor completely, costing closer to $2,000.
How do you fix polyurethane mistakes on the floor?
Most of the polyurethane mistakes can fix by sanding, re-application of the polyurethane finish, by using quality, a new can of polyurethane finish, not subjecting polyurethane can to extreme weather, cleaning the surface well before applying polyurethane, and following proper guidelines when applying polyurethane …
Why is my hardwood floor crowning?
Wood floor crowning is the opposite of cupping and happens when the center of the board is higher than the edges. Like cupping, wood floor crowning happens because the boards are exposed to a moisture imbalance over an extended period of time. Crowning can also be caused by previous floor cupping.
Why is my floor coming up?
Laminate floor lifting or buckling can be caused by changes in temperature and humidity levels. Use a hammer and chisel or putty knife to remove baseboards or molding near the damaged boards. If spacers were used between the wall and the board closest to it, replace them with smaller spacers.
Why is there a hump in my floor?
When a floor joist or joists are too long and extend past the center beam, they can cause a hump in the floor. A wood floor joist will deflect or sag near the center of the joist under the weight of the flooring and furniture.
Why are my floor boards lifting?
Lifting in the Center
This is usually caused by sanding a cupped floor before it has completely dried, although moisture on the upper side of the floor caused by plumbing leaks or wet mopping may cause floors to crown as well. Prolonged periods of high relative humidity can also result in temporary crowning.
What causes soft spots in hardwood floors?
Three major causes of soft spots include excessive moisture, an expansion gap, an unbalanced subfloor, and pests.
Why does my wooden floor bounce?
A wood or laminate floor can only bounce when there is a gap between the underside of the plank and the sub-floor. When weight is applied to the flooring, it moves downward because it is not supported, causing the bounce.
How much does it cost to fix soft spots in floor?
Subfloor Water Damage Repair Cost
The cost to repair or replace plywood subfloors will be $1.50 per square foot for materials and between $25 and $30 per hour for labor.
