There are purists out there that may say it must be level, but if it looks good setting there, I would let it set on the floor with no shims. It should not affect the operation of the flapper or valve that flushes the toilet.

Does it matter if toilet flange is not level?

Quote from the video:
Quote from Youtube video: Level it's going to be a problem trying to stall a toilet on that once the tile is done. So here's an example right here where you'll see that this flange has an angle on it has a gap underneath.

How do you level the front and back of a toilet?





Quote from the video:
Quote from Youtube video: I like using plastic shims for this it beats going out there and getting your floor set and try to make a big mess trying to just level it out a little bit these floor shims are able to be stacked.

Should a toilet be level with the floor?

The optimum flange height to aim for is 1/4 inch above the finished floor. This typically allows for almost any type of wax ring to be used and still ensure a good seal.

What do you do if your toilet isn’t leveling?

Hammer a shim gently between the floor and the toilet base to bring a low side up. Continue to check the level in several directions around the toilet bowl and add more shims as necessary to level the bowl. When the bubble is level in all directions then tighten the bolts down firmly.

Does a toilet have to be level side to side?

Most toilets commonly found in the home can function even if they are not level. However, if a toilet is not level and rocking side to side or back and forth, it can quickly cause damage to the wax seal and flange, leading to leaks. It is best to ensure that a toilet is level when it is installed.

Can you shim the back of a toilet?





Quote from the video:
Quote from Youtube video: Make sure that when you're putting the shims at the base of the toilet you aren't lifting the toilet too high and separating the wax ring that's your seal to keep the water from flowing. Out.

Why is my toilet slanted?

A slow leak over many years can cause wet rot and decay damage to the subfloor, and the toilet may start to lean to one side. If you do not have one of the new low-flow toilets, it might be a good idea to replace the older toilet or at least add a 1-gallon milk jug or tank bag to the tank to displace the stored water.

How do I fill the gap between my toilet and floor?

Apply a thin, even bead of caulk around the base of the toilet to cover the gap along the floor and hide the shims. If necessary, smooth the caulk with your finger, wiping your finger clean frequently with a paper towel or a rag.

Should the back of the toilet touch the wall?

There is no hard-fast rule about whether a toilet should touch the wall, as it is a matter of personal preference. Some people are okay with a toilet tank’s top touching the back wall, while others desire a minimum of one inch of space between the commode and the back wall.

Should toilet flange be flush with floor?



Quote from the video:
Quote from Youtube video: Thing you want to do is remember that all toilet flanges should always be installed on top of the finished floor.

How much space should be between toilet flange and floor?

For those that don’t already know, the proper toilet flange height is when it’s flush with the top of the finished floor. The optimum height is about ΒΌ inch. It’s easier to get your flange flush with the floor if you lay your flooring before you install the flange.

How do you install a toilet when the flange is too low?

If you do have the problem of a too-short flange, there is a fairly easy solution. It’s called a toilet flange spacer, or a toilet flange extender. They are available in different sizes based on different needs; some even have rubber or silicone gaskets attached that get inserted into the existing flange.

Can a toilet flange be too high?



When your toilet flange is too high, your toilet may leak water and rock back and forth when used. Both the leaking and the rocking can warp or break the floor. A leaking flange can also rot the subfloor and lead to the accumulation of mildew and mold.