How do you separate a pump?

Quote from the video:
Quote from Youtube video: Here. You can see Nick I'm screwing those bolts. Now once these bolts come off you're gonna want to use a mallet a screwdriver or even a pry bar to get those two pieces apart.

How do you separate a jet pump from a motor?





Quote from the video:
Quote from Youtube video: And then remove the diffuser. And check for wear or damage. Now using a flat head screwdriver hold the motor shaft and loosen the impeller by stringing it in a counterclockwise. Direction and remove.

How do you disassemble an impeller?

Quote from the video:
Quote from Youtube video: You can now remove the impeller wrench using the knurled section of the socket. You can loosen the impeller safely until you can remove it from the pump shaft.

How do you remove an impeller from an electric motor?

Quote from the video:
Quote from Youtube video: Off the center rubber cap revealing a small crevice wide enough to be held still with the flat-head screwdriver to prevent it from turning lock. The back from spinning. While you unscrew the impeller.

How do you remove the impeller from a jet pump?

Remove and seperate the whole jet pump from PWC. Hold the front end of the drive shaft with a SHAFT HOLDER on bench vise. Remove the impeller. Turning clockwise will loosen the impeller.

How do you remove a water pump impeller?





Quote from the video:
Quote from Youtube video: Use a 2×4 and a hammer and firmly knock the impeller counterclockwise to loosen it then carefully remove it from the engine and pump base. Step 3 install your new impeller. And twist it on clockwise.

How do you remove an impeller cover?

Quote from the video:
Quote from Youtube video: After removing all the nuts go ahead and shift the rubber hose downward. And remove it from this connection. Point everything is loose you will carefully grab it at a firm location.

How do you remove a centrifugal pump impeller?

When disassembling the impeller, use a special wrench to unscrew the impeller nut in the same direction as the impeller rotation, remove the retaining washer, and the impeller can be removed. If it can not be removed, the sleeve can be sleeved with a sleeve, and the casing head can be gently tapped with a hammer.

How do you remove an impeller bolt?

Quote from the video:
Quote from Youtube video: So I'll show you the same turning it in what you think it would be the tightening direction but not for the left-handed thread you have to turn it clockwise to get it all.

How do I remove a stuck outboard impeller?



Quote from the video:
Quote from Youtube video: Got rid of a little bit of this rubber here. And I came at it with a dremel. You kind of Dremel like this. And I actually cut you can look at this. I.

How do you remove a Hayward pump impeller?

Quote from the video:
Quote from Youtube video: You want to remove it or it's burnt out we want to change the mechanical seal behind the impeller. We're going to show you how what you're going to need is a 7/16 wrench or a 10 millimeter wrench.

How do you free a stuck pool pump impeller?

Quote from the video:
Quote from Youtube video: Not priming I think the impellers clogged. If you want to make sure that's not going to come back on while you're doing the impeller clearing. So we just take the lid. Off.

How do you open the impeller on a pool pump?



Quote from the video:
Quote from Youtube video: Make a slight Bend about 6 inches up the wire. To allow for better maneuverability. Step 3 clean out and power insert the wire slowly into the opening leading to the empower. Until it stops.