Place a thick board on the ground next to the post and set your bumper jack on it. Then loop a sturdy chain around the post down near the base, with the chain hooked over the lifting hook on the jack. Pumping the jack handle should pull the post upward until it is loose enough to lift out.7-noy, 1996
How do you get a steel post out of the ground?
Quote from the video:
Okay so what you're going to want to do is take your strap or rope or whatever I just happen to be using a load strap from my truck and days what I do is I just make like a loop.
How do you pull a post out of the ground?
Quote from the video:
I need a fulcrum in that I'm using a cinder block you can use a stump or a chunk of wood maybe a five-gallon pail. Whatever you need to create an anchor.
How do you remove a metal fence post with a car jack?
Low Effort Fence Post Removal
- Step 1: Clear the Area Around the Post and Get Your Tools Ready. You need to ensure clear solid ground around the post. …
- Step 2: Twist a Wire Loop Through the Lowest Holes and Position the Jack. …
- Step 3: Position the Jack and Raise It. …
- Step 4: Lower Lift and Remove Post!
How do you lift a post?
Quote from the video:
Get it nice and tight slip hook as as you see it here you take your high lunge at. It is close to the stump as possible for the base of the post. So you wrapped around hook.
How do you remove old metal fence posts?
Quote from the video:
Go ahead and spray the hole out and make sure there's no dust left in there and we're gonna go ahead and apply the red head drop in anchor we'll just tap that in with a hammer.
How do you remove a metal fence post spike?
Quote from the video:
Just take a little bit into the ground first and get it underneath this collar right here. Because. If you try and pull it right straight up it won't come you have to actually bend.
How do you remove a fence post from a floor jack?
Quote from the video:
Because the round area of concrete that I was trying to pull the post out of is probably was pushing up against the bottom of the jack therefore causing way more pressure on the 2×6.
How do you remove a fence post without Jack?
If you don’t have scrap lumber, you can use a spade bit to drill a hole in the side of the post, large enough to insert the pry bar and get leverage. Another option is to drill a hole clean through the post, with a diameter big enough to slide your bar through.
How do you remove a stubborn fence post?
Quote from the video:
We should be able to just pull it out best method is to wiggle it like an old tooth. And there it is.
How do you remove a fence post without concrete?
Quote from the video:
So here's another method that you can use to get out your met fence post. So basically what you're gonna do is you're just gonna dig a hole on one side of the fence post.
How do you remove metal stakes from the ground?
Quote from the video:
Take one of the pieces of pipe. And stick it through the loop that you just made in the chain. Place the pipe up against the fulcrum. And apply downward pressure as close as you can get to the end.
How do you remove a metal pole from concrete?
Quote from the video:
Once you've got enough stuff dug up and you can drill some holes drill some holes. Again. Be safe if you've never drilled metal before it might very well be difficult.
How do you get a deep pole out of the ground?
Quote from the video:
Ah but you have to do with that chain wrap it around the post the grips the clothes.
How do you remove concrete post base?
How to Remove Concrete Post Footings
- Brush away loose dirt to expose the top of the concrete footing at the base of the post.
- Loosen the upper layer of soil around the outer edge of the concrete footing, using a digging bar. …
- Break the concrete footing into two or more sections, using a cold chisel and steel mallet.