How do you install a dimmer switch on a circuit?


Quote from Youtube video: Start by wiring the bear ground wire from the house to the green ground wire on the three-way switch screw on a wire nut and tighten it. Down.

Can you put a dimmer on a two switch circuit?

If you have a 2-way circuit (where the same lights are controlled by two switches) you must choose a push-on/push-off dimmer and replace one of the switches with that dimmer. You can only use one push-on/push-off dimmer in a 2-way circuit. It must be used in conjunction with a normal switch.

How do you install a dimmer switch on a single switch?

Quote from the video:
Quote from Youtube video: First thing you want to do is turn off the power to the circuit you're working on and double check it with a tester remove the cover and pull out the old switch.

Can you add a dimmer to any light?

Most light fixtures will work with standard dimmer switches, including those with halogen and incandescent lamps. Determine whether your fixture uses line or low voltage. If you install line-voltage track and rail lights with incandescent bulbs, you can use dimmer switches to control their brightness.

How do I install a dimmer switch without a ground wire?

In that case, an exception in article 404.9(B) of the current National Electric Code (NEC) allows a dimmer without a connecting ground wire to still be installed if it is a replacement. Simply remove the dimmer wire, or cut it short and cap it with a wire nut.

Can you put a dimmer switch on any switch?

A dimmer switch can be installed anywhere that an existing on or off switch is in place. Replacing the current toggle switch with a dimmer switch will allow you to change the lights’ brightness, so long as you are using a light bulb that is compatible with the dimmer you have chosen.

How do you install a 2 way dimmer switch?

Quote from the video:
Quote from Youtube video: Choose which one of these switches you would like to replace with the dimmer to begin turn off the power at the circuit. Breaker. Now remove the switch plate and unscrew the existing device from the