Why do chainsaw bars have holes?
These two holes are used to hold the saw blade. if your chainsaw blade not have holes or just have one hole. it not work. if you know how to drill, you can drill two holes on your chainsaw blade.
Why do Loggers put chainsaw bars upside down?
Every chainsaw bar has been designed to be mounted right-side up or upside down. The reason for this is that it allows the user to extend the life of his chainsaw bar by 50%. Flipping the bar will give the heavily-used areas some relief from wear and tear.
Can you change the size of your chainsaw bar?
Replacing your chainsaw bar will require a few measurements. Most chainsaws can operate up to three different bar sizes. Guide bars are measured in length, from the tip of the bar to the heel, and range in size from 14 to over 40 inches.
How do you close the gap on a chainsaw bar?
Quote from the video:
Quote from Youtube video: And realized that the bearing was an easy one I already had on the show so that was a little stroke of luck. But basically this tool you just spin this closed to tighten it open to loosen it.
Why is my chainsaw blade smoking and not cutting?
This most commonly is a result of a dull chain and exerting to much pressure on the bar and chain trying to make the chain saw cut. This could also be either a lack of bar and chain oil ( tank empty, restricted oiler hole ) or an inferior type of oil that is being slung off the chain and not lubricating.
How often should chainsaw be sharpened?
A chainsaw may only need to be sharpened once a year if it is rarely used, but a tool that is frequently used will need to be sharpened regularly to ensure that the blade doesn’t get too dull. On average, a chainsaw blade will retain its sharpness for about 3 hours of actively cutting through wood.
Why does my chainsaw chain dull so quickly?
If your chain dulls quickly, then it could be a couple of things. Check your user’s manual to ensure that you are using the right sized file for your chain. Alternatively, you could be applying too much pressure when you file. This will create cutting edges that are too thin and dull quickly.
What angle do you sharpen a chainsaw?
between 25° and 35°
The sharpening angle will generally be between 25° and 35° – the harder the wood, the greater the angle. To maintain the correct angle, we recommend that you use a sharpening grid or a filing gauge as an aid.
Is it OK to use chainsaw in the rain?
Petrol powered chainsaws can be used in all types of weather. Be it blazing sun or a dull and rainy day. While you may be worried about using your chainsaw in wet conditions, the chainsaw is not the main issue. Sodden ground and wet wood can be exceptionally slippery.
Can you cut frozen wood with a chainsaw?
It’s not impossible to cut frozen wood with a chainsaw, but it is extremely difficult. Cutting wood requires a sharp chain and frozen wood will dull your chain. You will have to perform additional maintenance on your chainsaw in the winter months and wear protective gear in order to successfully cut frozen wood.
Is it easier to chainsaw wet or dry wood?
Dewdrops, raindrops, or the snow on the wood will not cause any harm to your chainsaw. It is, in fact, much easier to cut through the wet wood than dry wood because the extra moisture on the wood will act as a natural lubricant.
Can you split wood with a chainsaw?
Quote from the video:
Quote from Youtube video: So low so you start bringing the chain down into the wood okay. Right at the center points okay obviously if you guys while you could follow a crack. But since this is all my splitting.
How long should logs sit before splitting?
about six months
The most important rules for preparing good firewood are: Cut, split and stack the wood in the early spring and let it stand in the sun and wind until it is seasoned. For many people seasoning will take about six months. for others, it will be a full year, depending on climate and wood species.
Is there a trick to splitting wood?
Quote from the video:
Quote from Youtube video: The it'll just kind of break open a lot of times it's a lot easier if you kind of like start on the far side and you hit it over here. And then kind of hit on this side you kind of work the sides.
