How do you replace a rotted fence post?

Quote from the video:
Quote from Youtube video: By cutting the post above. And below the rail we're gonna release the rail. So they can swing out and then we can work on the post. Now we'll just bang out the pieces of the post with a hammer.

What is a deck footing?

Footings are a very important component of deck construction because they provide the solid foundation that will support your deck. Your deck’s design will determine how live and dead loads are transferred from different sections of the deck to concentrated points of contact with the ground.

How do you build a deck footer?

Quote from the video:
Quote from Youtube video: Then fill the bottom of the hole with six inches of quikrete all-purpose gravel and compact the gravel with a two-by-four or wood post measure. And Mark the quick tube for the hole depth.

How do you remove a rotten fence post set from concrete?

Quote from the video:
Quote from Youtube video: You just double up your posts to give you a bit more of an angle. Let's pull more post out. And then that should be ready to just pull out by. Hand and there you go.

How do I remove old wood fence posts?

Quote from the video:
Quote from Youtube video: So basically what you're gonna do is you're just gonna dig a hole on one side of the fence post. Like this dig that out you know pile the dirt up over here whatever.

What is the best type of footing for a deck?

Poured concrete footings, buried post footings, precast cement footings, deck blocks, and screw/helical piles are all viable options for deck footings.

Are deck footings necessary?

Large decks that are attached to the house should always have footings because they act to spread the heavy load of the deck from the surface of a support post over a large surface of the soil so the ground can adequately support it.

Does a freestanding deck need footings?

According to the main code provision for footings, the only requirement for building a deck that is freestanding is that it must have a minimum footing depth of 12 inches below the undisturbed ground surface. There is no need to extend a footing below the frost line, as is required for standard decks.

How do you remove a wood fence post from concrete?

  1. Step 1: Remove Old Wooden Post. …
  2. Step 2: Dig around the perimeter of the posthole. …
  3. Step 3: Break up the Concrete Footing. …
  4. Step 4: Remove Remaining Concrete. …
  5. Step 1: Dig around Posthole perimeter. …
  6. Step 2: Insert Prybars. …
  7. Step 3: Lever the Footing out of the Posthole. …
  8. Step 1: Drill Pilot Hole into Post.
  9. Can you reuse fence posts with concrete?

    Things You’ll Need

    Posts with concrete at the base are the most difficult to remove and reuse because the concrete base is larger than the post, which makes pulling it up through the ground much harder.

    How do you get old concrete posts out of the ground?

    Quote from the video:
    Quote from Youtube video: Simply move the soil from in front of that post. Over into the hole where the other post was. Now I'm simply going to take my shovel. Come in behind to post and push it forward just like that.

    How do you remove deck footings?

    Steps in Removing Concrete Deck Footings

    Using a spade shovel manually excavate around the footing at least 3/4 the way around and at least 2/3rds of the length of the footing. Dig until you see the footing wiggle a bit. The more you dig the easier the footing will come out.

    Can you reuse deck footings?

    If the footings appear settled, cracked, tilted or heaved they should not be reused. The next consideration is the deck load each footing is supporting. If the size of the footings is known, then the new deck design must not overload any existing footing.

    How do you replace old footings?

    Quote from the video:
    Quote from Youtube video: So what we did do though is we dug down beyond the wall almost aware the footing should be yep we've undermined this 12-inch wall just a little bit so will you say dug down you go deeper.

    How do you replace a load bearing post?

    Quote from the video:
    Quote from Youtube video: Back here with these longer posts these longer joists that go all the way across. And. So I'm going to tie things together first off. So it's less likely to slump when I take the weight off.

    How do you reinforce existing footings?

    Here are some commonly used methods.

    1. Underpinning. This method is used to either increase the depth of the foundation or to repair the foundation if it has significant damage. …
    2. Jacketing of Foundations. Another method you may hear about is jacketing of foundations. …
    3. Mudjacking. …
    4. House Lifting and Leveling.