How do you winterize your sprinklers yourself?
Quote from the video:
Quote from Youtube video: Now we're gonna start it's a very simple process by shutting off the water flow to your sprinkler. This is usually located inside. The house usually with a ball valve.
How do you bleed a sprinkler system for the winter?
Quote from the video:
Quote from Youtube video: And we're going to turn these to 45 degrees with our screwdriver. You're going to see some water drain out from both of those. Go around leave those at 45 degrees.
How do I winterize my sprinkler system without an air compressor?
You can winterize a sprinkler system without an air compressor if all of your irrigation lines are buried at a slight downhill slope. Simply shut off the main water supply to your system and open the drain valves at the end of each zone.
What PSI Do I need to winterize my sprinkler system?
50 pounds per square inch
Air pressure must not exceed 50 pounds per square inch (psi). Compressor must be capable of delivering 20 to 25 Cubic Feet Per Minute of air volume. Do not run equipment for longer than 1 minute on air.
Should I run my sprinklers before a freeze?
It is best to turn on your system during the warmest time of the day when anticipating freezing conditions. Be sure the outside temperature is 37 degrees or above when you run your system. You ABSOLUTELY do not want to run your sprinkler system during a hard freeze as this will cause damage to your irrigation system.
How do I turn off my sprinkler system for the winter?
Quote from the video:
Quote from Youtube video: Right here which is a ball valve that requires a quarter. Turn. So that the handle is at a right angle or 90 degree angle to the pipe. So that means it's shut off now.
Where do you plug in air compressor to sprinkler system?
Sprinkler systems feature a fitting to allow the connection of an air compressor.
- Locate the control panel for the sprinkler system. …
- Close the airflow valve on the compressor. …
- Go back to the control panel and manually open the sprinkler zone that is the farthest from the panel or at the highest point on the system.
