How do you join copper refrigerant lines?
Quote from the video:
Quote from Youtube video: When you're pressing these refrigerant lines what's most important is deburring the outside of the copper that way when you're sliding your fitting.
What are the 3 pins on a refrigerator compressor?
The 3 pins you’ll see are marked ‘S’; ‘C’; and ‘R’. These are the Start, Common and Run winding pins. If the pins aren’t marked, set the multi meter’s function switch to the R x 1 scale, and find the 2 pins that give the highest reading – those will be your Run and Start winding pins.
How do you solder fridge pipes?
Quote from the video:
Quote from Youtube video: We're gonna heat the steel first we don't need to heat that much. And we're going to come over to the copper we want to go ahead then use the flux again. And when it come over the copper this time.
What is the copper tube on a fridge?
Copper and plastic are two common materials for an ice maker water line, which is vital for refrigerators with water dispensers and ice makers.
How do I connect copper pipe without soldering?
Quote from the video:
Quote from Youtube video: Take two wrenches a relatively new type of connection is this a push connection. As its name suggests you push it on to the pipe until it bottoms out and now it's a watertight connection.
How do you connect refrigerant lines without brazing?
Quote from the video:
Quote from Youtube video: So you also don't need safety equipment fire spotters or hot work permits without brazing almost anybody can join tubes with zoom lock and you get more flexibility.
What causes fridge compressor to overheat?
There are several reasons for a compressor to run too hot, including high compression ratio, high return gas temperatures, and lack of external cooling. High compression ratios are the result of either lower than normal suction pressures or higher than normal discharge pressures.
How do you jump start a refrigerator?
Quote from the video:
Quote from Youtube video: All you do put your connection back on the back on the solenoid. There tighten up the screw. Go back into your van. Turn your fridge completely off wait for about 15 seconds.
What causes fridge compressor failure?
Too Little or Too Much Refrigerant
In the event that the amount of refrigerant in the system is not perfect, it could create too much pressure or strain and lead to compressor failure. Too little refrigerant is most likely caused by an insufficient charge from the last technician, or from a refrigerant leak.
How do you repair a copper refrigerator water line?
Quote from the video:
Quote from Youtube video: After damage pieces removed we're going to take this little piece that comes on your pipe cutter. And put it into the tubes. And return them to the original.
Where is all the copper in a refrigerator?
Copper – While you can’t cut the copper refrigerant lines, there’s often still a good amount of copper to be found when dismantling a refrigerator, due to the electrical components. Be sure to cut away and strip all wiring of insulation to find the valuable copper inside.
How do you fit a compression fitting to copper tubing?
Quote from the video:
Quote from Youtube video: Slide the compression fitting onto the tube until the tube bottoms out a drop of lubricating oil or thread sealant will ease not assembly thread the nut onto the fitting hand-tighten.
How do you solder copper pipe without flame?
Quote from the video:
Quote from Youtube video: Together we heat it up using one of these torches. Then we heat the fitting up up to a lovely hot temperature tap our solder on it.
How do you connect two pipes without threads?
You can try to thread the pipe or use pipe thread tape to create a bond between the two pipes. Another alternative would involve welding the pipes or connecting them using coupling.
