How do you patch a hole where an outlet was?

Quote from the video:
Quote from Youtube video: You can just cut off the extra. This is just pretty much to give our drywall mud a base. So I could jam this in there. But.

Can you patch over an electrical box?





As long as there are no wires inside the box, you can cover it with drywall. If the box is still acting as a junction box, however, and wires are joined inside it, the electrical code mandates a removable cover.

How do you repair drywall in electrical box?

An oversize drywall cutout around an electrical box can ruin the appearance of an otherwise perfect taping job. The best way to fix it is with drywall compound and joint tape.

How do you fix a hole in the wall without drywall?

Tiny nail and screw holes are the easiest to fix. Use a putty knife to fill them with spackling or wall joint compound. Allow the area to dry, then sand lightly. Anything larger must be covered with a bridging material for strength before patching compound can be applied.

How do you fill gaps around an outlet?

Quote from the video:
Quote from Youtube video: I'm using the all-purpose two-point compounds. And a piece of cardboard. So I can lay down the outlet patch on it and apply the joint compound to the back of the patch.

How do you plug a hole in an electrical box?





The idea is to press or hammer a plug into place from outside the box. The prongs compress and press inward to fit through the hole, then spring back into place to keep the plug snug against the box and virtually impossible to remove.

Is it safe to cover an electrical outlet with tape?

Answer: No. Although the application of electrical tape to conductive parts, as described above, will likely reduce worker exposure to the shock hazards of uncovered receptacles, it is not an acceptable alternative to retaining receptacle covers in place or turning off power.

How do you cover electrical outlets?

Use a box cover to fully cover the outlet. Box covers cover the entire outlet panel to prevent children or pets from accidental electrocution. Measure your outlet’s length and width, and choose a cover that matches the outlet’s dimensions. Find box covers at most hardware or home improvement stores.

Can I drywall over a junction box?

Junction box covers must remain accessible; they cannot be covered with drywall or other surface material.

Is it OK to cover a junction box?



2 Answers. Show activity on this post. You cannot cover any junction box that still has live wires in it. Your best bet is to either remove the box all together or just put a cover plate on it.

Can I bury an electrical junction box?

Article 314-29 of the National Electrical Code states that listed junction boxes may be buried without excavating parts of buildings, sidewalks, other paving, or earth.