How do you install a cheap curtain rod?
Quote from the video:
Quote from Youtube video: Slide the curtain rod bracket into the bottom of the wall bracket and you thread the screw down from the top to hold this bracket. This is where the curtain rod will. Rest.
How do you hang a metal curtain rod?
Place a curtain rod bracket at the desired location at one end of the window frame. Use the machined holes in the bracket as guides and mark the locations were holes will be drilled with a felt-tip marker. Repeat this step to mark the locations for holes where a bracket attaches at the opposite end of the curtain rod.
How do you install a basic curtain rod?
Quote from the video:
Quote from Youtube video: Drive the screws into the wall. And position the hanger. Flip to the opposite side of the window to make the remaining marks install the screws. And place the hanger. Feed the curtain onto the rod.
How do I put together my mainstays adjustable curtain rod?
Quote from the video:
Quote from Youtube video: And then you have to be careful this fill doesn't fit this because there's a there's a folded over piece of metal it goes on the other end. And then you have to push it it's real snug.
Can you hang curtain rods without drilling holes?
Dowels and Sticky Hooks
And the beauty of using a sticky hook instead of drilling holes in the wall is that if you decide the curtains look too low or too high, you can move the rod and hooks without any damage.
How do you attach a metal rod to the wall?
Drill a hole through one (or both) and the rod and pin it. Use a large cotter hairpin. That or if the hairpin looks is too much just drill and tap through the bracket into the metal rod and use a eye bolt or some type of screw with a handle.
How do you screw a rod into a metal door?
Place a level across the top of the rod and reposition the magnetic brackets until the rod is level. If you’re also installing a lower sash rod, insert the rod into the lower curtain casing, then assemble the magnetic ends on the rod and position it on the door. Check the lower rod with the level if desired.
How do you drill through a metal window frame?
Put a small drill bit in the drill to make a pilot hole. Press lightly against each hollow and use a slow to medium drill speed. Continue drilling until you penetrate the metal. Then set the drill on reverse and slowly pull the bit from the hole.
How do you hang a curtain rod without studs?
If there isn’t a stud, you need to use a drywall anchor and a screw to reinforce your curtain rod brackets. Without a drywall anchor, a screw won’t be able to hold the weight of your curtain rod. You risk pulling the brackets out of the wall and causing further wall damage.
Can you install curtains with a screwdriver?
A handheld screwdriver works well for the last few turns. Once you have your brackets attached to the wall, you’re ready to hang your curtain rod! It’s easiest to thread your curtains on the rod beforehand.
Do you have to use anchors for curtain rods?
You’ll need to use plastic wall anchors to provide proper support if you’re installing in drywall. Fasten the brackets to the walls using your drill or screwdriver. Having a hand tool ready often makes this job easier, since it can be hard to use a larger electric drill when mounting curtain rod hardware to the wall.
How far should a curtain rod extend past window?
As a general rule, drapes will be open during the day, so make sure the curtain rod extends at least four inches on each side of the window’s inside frame. To create the illusion of a wider window, extend the rod up to 10 inches beyond the window’s frame.
How much wider Should a curtain be than the window?
2 to 2.5 times
How wide should curtains be? To ensure that curtain panels look ample when closed, they should have a combined width that is 2 to 2.5 times the width of the window/rod. That means if you are ordering Grommet style or Rod-pocket style, the total drapery width should be at least 2 times the window/rod widths.
Do curtains need to touch the floor?
It depends on factors such as window length, but more often than not, curtains look best when touching the floor. However, how low you want your curtains to hang will determine what you want to achieve. In reality, different decorating styles employ varying curtain lengths.
How far off the ground should curtains be?
The proper position is ½ inch above the floor for free hanging curtains. This distance allows for mopping and cleaning while creating the illusion that the curtain touches the floor.
How wide should you hang curtain rod?
Each curtain panel should be at least as wide as your window. Measure from the spot you plan to hang the rod (usually four to six inches above the window, but a minimum of two inches) to the floor to figure out the length of the curtains.
How high should a curtain rod be for 84 inch curtains?
The length of the curtain dictates the height of the rod. If you buy 84-inch-long curtains, the rod must be mounted roughly 84 inches from the floor if the curtains hang from the rod without rings. This lets the hem of the curtains brush the floor.
